629293
8
Zoom out
Zoom in
Previous page
1/48
Next page
8 — Installation & Programming Guide
Connector CN11 SPKR + For optional speaker
-
ST Stobe trigger -ve applied
OP2 Programmable general purpose output (default +ve
applied sounder trigger used if relay is not fitted)
TAMPER - Tamper feed
R Tamper return
(Tamper can be used for sounder case or detector
loop if required)
Connector CN12/ Dialler Connections
CN13 BC
TB
B 50v Line connection
GND
A 50v Line connection
TA
Connector CN14 EXT SNDR NO
(Relay) C
NC
(Relay not fitted on all versions)
Sounder
Connections
Sounder output descriptions
ST This output goes to 0V in alarm and will allow the strobe to
trigger.
AUX+ 12V supply to the sounder used to hold off signals until
there is an alarm.
OP2 or
RELAY OP 12V signal to the sounder used to hold off signals until
there is an alarm.
TAMPER R Tamper return for sounder, case tamper for sounder
should be connected in series.
TAMPER - Tamper feed or -VE hold off or -VE supply.
}
Uncommitted relay contacts for sounder trigger
CN11
SAB or Bell Box
T
A
M
P
OP2 or
RELAY OP
Tamper Feed
A/T Return
-VE Hold Off /
-VE Supply
+VE Supply
-VE Sounder Trigger
+VE Supply Hold Off
R
-
AUX +
ST
Tamper Loop
CN11 and/or CN14
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Guardall WINDSOR SERIES 300i at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Guardall WINDSOR SERIES 300i in the language / languages: English as an attachment in your email.

The manual is 0,3 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info