629293
7
Zoom out
Zoom in
Previous page
1/48
Next page
Installation & Programming Guide — 7
MAIN PCB
Connector CN1 A.C. Input (18 V ac)
Connector CN2 Battery Connection
Connector CN3 NVM Reset - Fit link across CN3 in depowered condition. Power up
unit. Mains LED flashes. Remove link and when Mains LED stops
flashing, the panel has defaulted.
Connector CN4
Remote Set/Unset - when connected to a suitable device (i.e.
keyswitch or other latching device) when contacts are closed, panel
will set and when contacts are open, panel will unset.
Alternatively, this input may be programmed as a Push Button input.
Connector CN5 Connection to detectors for alarm and tamper inputs.
CN6/CN7/CN8 To connect detectors, wire them as illustrated below,end of line
resistor values are 2k7 & 8k2.
Connector CN9 Aux +
-
I
P
OP 1 Programmable general purpose output
Connector CN10 +12V
0V
Aux
CN5/6/7/8
CN5/6/7/8
Aux
+12V
1 to 8
COM
0V
+12V
Alarm
Tamper
0V
8k2
2k7
}
+12V and 0V for keypads
}
connections for keypads
}
Aux for Zone inputs
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Guardall WINDSOR SERIES 300i at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Guardall WINDSOR SERIES 300i in the language / languages: English as an attachment in your email.

The manual is 0,3 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info