544906
57
Zoom out
Zoom in
Previous page
1/92
Next page
57 / 92 EN
Washing Machine / User‘s Manual
Installation
3.5 Connecting to the drain
Connect the end of the drain hose directly
to the wastewater drain, sink or to the
washbasin.
A
WARNING: Your house will be
flooded if the hose comes out of its
housing during water discharge.
Moreover, there is risk of scalding
due to high washing temperatures! To
prevent such situations and to ensure
smooth water intake and discharge of
the machine, fix the end of the discharge
hose tightly so that it cannot come out.
Attach the hose at a height of at least 40
cm, and 100 cm at most.
In case the hose is elevated after laying
it on the floor level or close to the ground
(less than 40 cm above the ground), water
discharge becomes more difficult and the
laundry may come out excessively wet.
Therefore, follow the heights described in
the figure.
To prevent flowing of dirty water back
into the machine and to allow for easy
discharge, do not immerse the hose end
into the dirty water or do not drive it in the
drain more than 15 cm. If it is too long, cut
it short.
Pay care not to bend the end of the hose,
step on it or pinch the hose between the
drain and the machine.
If the length of the hose is too short, use
it by adding an original extension hose.
Length of the hose may not be longer than
3.2 m. To avoid water leak failures, the
connection between the extension hose
and the drain hose of the product must be
fitted well with an appropriate clamp as
not to come off and leak.
3.6 Adjusting the feet
A
WARNING: In order to ensure
that the product operates more silently
and vibration-free, it must stand level
and balanced on its feet. Balance
the machine by adjusting the feet.
Otherwise, the product may move from
its place and cause crushing, noise and
vibration problems.
1 Loosen the lock nuts on the feet by hand.
2 Adjust the feet until the product stands level
and balanced.
3 Tighten all lock nuts again by hand.
A
WARNING: Do not use any tools
to loosen the lock nuts. Otherwise, they
will get damaged.
57


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Grundig GWN 47230 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Grundig GWN 47230 in the language / languages: German as an attachment in your email.

The manual is 4,71 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info