544906
56
Zoom out
Zoom in
Previous page
1/92
Next page
56 / 92 EN
Washing Machine / User‘s Manual
Installation
3 Attach the plastic covers supplied in the
User Manual bag into the holes on the
rear panel. (P)
C
Keep the transportation safety bolts in
a safe place to reuse when the washing
machine needs to be moved again in
the future.
C
Never move the product without the
transportation safety bolts properly fixed
in place!
3.4 Connecting to the
water supply
C
The water supply pressure required to
run the product is between 1 to 10 bars
(0.1 – 10 MPa). It is necessary to have
10 – 80 liters of water flowing from the
fully open tap in one minute to have your
machine run smoothly. Attach a pressure
reducing valve if water pressure is higher.
C
If you are going to use the double water-
inlet product as a single (cold) water-
inlet unit, you must install the supplied
stopper to the hot water valve before
operating the product. (Applies for the
products supplied with a blind stopper
group.)
A
WARNING: Models with a single
water inlet should not be connected to
the hot water tap. In such a case the
laundry will get damaged or the product
will switch to protection mode and will
not operate.
A
WARNING: Do not use old or used
water inlet hoses on the new product. It
may cause stains on your laundry.
1 Connect the special hoses supplied with
the product to the water inlets on the
product. Red hose (left) (max. 90 ºC) is for
hot water inlet, blue hose (right) (max. 25
ºC) is for cold water inlet.
A
WARNING: Check that the cold and
hot water connections are made correctly
when installing the product. Otherwise,
your laundry will come out hot at the end
of the washing process and wear out.
2 Tighten all hose nuts by hand. Never use a
tool when tightening the nuts.
3 Open the taps completely after making
the hose connection to check for water
leaks at the connection points. If any leaks
occur, turn off the tap and remove the nut.
Retighten the nut carefully after checking
the seal. To prevent water leakages and
damages caused by them, keep the taps
closed when the machine is not in use.
56


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Grundig GWN 47230 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Grundig GWN 47230 in the language / languages: German as an attachment in your email.

The manual is 4,71 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info