574851
11
Zoom out
Zoom in
Previous page
1/20
Next page
11
OPERATION ________________________________
Fixing the frame
7
Loosen the two screws fastening the lower
chimney and re move this from the lower frame.
7
Loosen the two screws fastening the upper
chimney and remove this from the upper frame.
If you wish to adjust the height of the frame, pro-
ceed as follows:
7
Unfasten the eight metric screws joining the
two columns, located at the sides of the frame.
7
Adjust the frame to the height required, then
refit all the
7
Insert the upper chimney stack from above,
and leave it run running free on the frame.
7
Lift up the frame, fit the frame slots onto the
screws up to the slot end positions.
7
Tighten the two screws and fasten the other two
screws provided with the hood.
Before tightening the screws completely it is pos-
sible to adjust the frame by turning it. Make sure
that the screws do not come out of their seats in
the slotted holes.
7
The frame mountings must be secure to with-
stand the weight of the hood and any stresses
caused by the occasional side thrust applied
to the device.
7
In all cases where the ceiling is not strong
enough at the suspension point, the installer
must provide strengthening using suitable
plates and backing pieces anchored to the
structurally sound parts.
Ducted version air exhaust
system Connection
When installing the ducted version, connect the
hood to the chimney using either a flexible or
rigid pipe ø 150 or 120 mm, the choice of which
is left to the installer.
7
To install a ø 120 mm air exhaust connection,
insert the reducer flange 9 on the hood body
outlet.
7
Fix the pipe using the pipe clamps 25 (not pro-
vided).
7
Remove any activated charcoal filters.
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Grundig GDI5792 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Grundig GDI5792 in the language / languages: English as an attachment in your email.

The manual is 1,47 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info