790928
12
Zoom out
Zoom in
Previous page
1/20
Next page
12
Subsequent start-up
WARNING
If at any time, the grill fails to light or the re in the repot goes out while cooking
or smoking, when sufcient pellets are still in the pellet hopper, it is important
to follow these steps. Failure to do so may cause a hazardous ‘over-ring’ of your
grill due to an excess of unburned pellets in the repot.
1. Turn the switch OFF (O) and disconnect the power cord. If the grill is still hot, allow it to
thoroughly cool. Open the door and remove all food, the porcelain grills, grease drain pan
and the heat bafe.
2. Remove all unburned pellets and ash from inside and around the repot.
3. Before replacing the heat bafe, grease drain pan and the porcelain grills, plug the power
cord into an appropriate, grounded electrical outlet and restart the grill. Pellets should fall
into the repot and the hot rod should begin to heat (it will start to turn red). Do not touch it.
4. If this procedure is successful, you will soon see ames come out of the repot. Then turn
the switch OFF (O), and let the grill cool down. Position the heat bafe, the grease drain
pan and porcelain grill in their proper locations. With the door open, turn the switch ON (I)
and the temperature/dial to ‘Smoke. In approximately 2 minutes you will notice whitish-gray
smoke coming out of the grill as the pellets ignite. After assuring the pellets have ignited,
close the door and set the temperature/dial to any cooking setting desired.
5. If this procedure is not successful, see ‘Frequently asked questions’ for troubleshooting tips
or contact Grill Guru technical support to help diagnose the problem before proceeding to
the ‘Manual lighting instructions’ below.
1. MANUAL LIGHTING INSTRUCTIONS
If the hot rod only is not operating, the grill can still be used to cook and smoke using the
‘Manual lighting procedure’ below:
1. Turn the switch OFF (O) and disconnect the power cord. Allow the grill to thoroughly cool if it
is still hot. From beneath the pellet hopper, disconnect the hot rod (purple/white wire pair as
shown in the wiring diagram near the end of this manual). You will need to remove the hopper
bottom panel to access the wiring. Once the hot rod is disconnected, replace the hopper
bottom panel and plug the power cord back into an appropriate, grounded electrical outlet.
2. Open the pellet hopper and ll with pellets. Use only diameter 6 mm pellets only which
are specically made to work in our grills. Never use heating fuel pellets in the grill due to
potential hazardous contaminants and additives that may be present.
3. Remove the porcelain grills, grease drain pan and heat bafe to expose the repot in the
bottom of the grill.
4. Pour 1/2 cup of pellets into the repot.
5. Squirt 2 tablespoons of alcohol gel re lighter into the repot on top of the pellets. Never use
gasoline, gasoline-type lantern fuel, kerosene, charcoal lighter uid or similar liquids to start
or ’freshen up’ a re in this grill. Keep all such liquids well away from the grill when in use.
6. Carefully light the alcohol gel with a replace match or a long-reach butane lighter.
Never squirt alcohol gel into a burning re or a hot repot. The alcohol gel bottle could
explode and cause a re, serious injury or death.
7. Let the alcohol gel and pellets burn for approximately 4 minutes.
8. After assuring the pellets have ignited, install the heat bafe, grease drain pan and porcelain
grills back in place. You will now have a re in the repot. Be careful not to burn yourself
when you install these components. Gloves are recommended.
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Grill Guru Pellet Grill Large at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Grill Guru Pellet Grill Large in the language / languages: English as an attachment in your email.

The manual is 2.08 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Grill Guru Pellet Grill Large

Grill Guru Pellet Grill Large User Manual - Dutch - 17 pages

Grill Guru Pellet Grill Large User Manual - French - 17 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info