644728
18
Zoom out
Zoom in
Previous page
1/124
Next page
ENGLISH
(Original instructions)
1
Ƈ Health hazards caused by breathing dust developed
when using your tool (example:- working with wood,
especially oak, beech and MDF).
Additional safety instructions for batteries and chargers
Batteries
Ƈ Never attempt to open for any reason.
Ƈ Do not expose the battery to water.
Ƈ Do not expose the battery to heat.
Ƈ Do not store in locations where the temperature may
exceed 40°C.
Ƈ Charge only at ambient temperatures between 10°C and
40°C.
Ƈ Charge only using the charger provided with the
appliance/tool. Using the wrong charger could result in an
electric shock or overheating of the battery.
Ƈ When disposing of batteries, follow the instructions given
in the section “Protecting the environment”.
Ƈ Do not damage/deform the battery pack either by
puncture or impact, as this may create a risk of injury
Ƈ Do not charge damaged batteries.
Ƈ Under extreme conditions, battery leakage may occur.
When you notice liquid on the batteries, carefully wipe the
liquid off using a cloth. Avoid skin contact.
Ƈ In case of skin or eye contact, follow the instructions
below.
Warning!
damage to property. In case of skin contact, immediately rinse
with water. If redness, pain or irritation occurs seek medical
attention. In case of eye contact, rinse immediately with clean
water and seek medical attention.
Chargers
check that the mains voltage corresponds to the voltage on
the rating plate.
Warning! Never attempt to replace the charger unit with a
regular mains plug.
Ƈ Use your Greenworkstools charger only to charge the
battery in the appliance/tool with which it was supplied.
Other batteries could burst, causing personal injury and
damage.
Ƈ Never attempt to charge non-rechargeable batteries.
Ƈ If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised Greenworks tools Service
Centre in order to avoid a hazard.
Ƈ Do not expose the charger to water.
Ƈ Do not open the charger.
Ƈ Do not probe the charger.
Ƈ The charger must be placed in a well ventilated area
when charging.
Symbols on the charger
The following symbols are found on your charger:
Your charger is double insulated; therefore no
earth wire is required. Always check that the
mains voltage corresponds to the voltage on the
rating plate. Never attempt to replace the charger
unit with a regular mains plug.
If the cord is damaged, it must be replaced by the
manufacturer or an authorised Greenworkstools
Service Centre in order to avoid a hazard.
The charger is intended for indoor use only.
Read the instruction manual before use.
Features
1. On/off switch
2. Lock-off button
3. Main handle
4. Saw head
5. Sprocket cover
6. Guide bar
7. Chain
8. Chain sheath
9.
10.
11. Oil tank
Extension tube
Battery
Fig. A
12. Charger
Assembly
Warning! Before assembly, remove the battery from the tool.
tool. Slide the battery into the receptacle and push until
the battery snaps into place.
Ƈ To remove the battery, push the release button (13) while
at the same time pulling the battery out of the receptacle.
Warning! To prevent accidental operation, ensure that the
battery is removed and that the chain sheath is in placed on
the saw chain before performing the following operations.
Failure to do this could result in serious personal injury.
achieve standard reach.
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Greenworks 20157 - G-MAX 40V at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Greenworks 20157 - G-MAX 40V in the language / languages: All languages as an attachment in your email.

The manual is 3,44 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info