637251

Graupner MZ-12 HoTT - S1002 Manual

7
Zoom out
Zoom in
Previous page
1/77
Next page
Assemble the transmitter’s rear case and switch to mode 2 from mode 1 at Stick mode page
in the transmitter programming setup section according to the manual.
Ratchet Type Options and Strength Adjustment for Throttle Stick.
There are two options for the ratchet type of throttle stick. The one is clank type generally operat
-
ing airplane and the other one is no-clank type usually operating helicopter.
The right sided screw of the black-colored circles on the below picture is for strength adjustment
of throttle ratchet spring in case of operating helicopter (no-clank type).
The left sided screw of the black-colored circles on the below picture is for strength adjustment
of throttle ratchet spring in case of operating airplane (clank type).
Therefore, you can pick your required type by tightening the related screw (left screw for air
-
plane; right screw for helicopter).
Please refer to the below picture, you can adjust the screw.
The sticks of mz-12 Europe Version shall be operated by tension Modes.
According to the below picture with guideline, after disabling the other side stick, you can pick
the throttle channel of mode 1 or 2.
The method of Disabling Tension
The both sticks could be used tension or throttle types according to the users.
At rst, you can open the case of Transmitter.
If you turn the screw clockwise at the blow black-colored circle, the tension function shall be
disabled.
If you want to use the one stick by throttle function, you can disable the tension of the stick.
Please refer to the below picture, you can adjust the screw.
9
10
Assemble the centering cam into the
throttle gimbal of mode 1 transmitter
and set the spring in the center
control part and the centering cam
with tweezers
Screw the disassembled tension
control bolt from the elevator gimbal
of mode 1 transmitter into the throttle
gimbal and adjust the bolt for the
desired control
Tension spring
7
Make sure to test all functions are normally operated in mode 2 before ying
NOTICE
… 7 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Graupner MZ-12 HoTT - S1002 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Graupner MZ-12 HoTT - S1002 in the language / languages: English as an attachment in your email.

The manual is 13,5 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info