467107

Graupner MX-16 HoTT Manual

48
Zoom out
Zoom in
Previous page
1/200
Next page
48
Updating the receiver firmware
reached, switch the receiver power supply off and re-
peat the update procedure, i.e. carry out each of the
steps described above once more.
If you accidentally attempt to load a version of the
firmware which is correct, but older than the one cur-
rently in the receiver, the screen will display a corre-
sponding warning:
Unless you really want to load older firmware, click
on “No” with the mouse, and load the correct *.bin file
using the “File Browse” button.
Finally you MUST initialise the receiver, i.e. reset
it to the factory default settings.
This is accomplished by switching the receiver off
and removing the interface lead.
Initialising the receiver4.
In the interests of safety you should now re-initial-
ise the receiver before re-using it. The screen-shot
shown above indicates this:
Hold the SET button on the receiver pressed in while
you switch the receiver on. The red and green LEDs
flash four times, followed by a pause lasting about
two seconds. At this point the red LED starts flash-
ing on its own. At this point you can release the SET
button.
Switch the transmitter on again, and wait until RF
transmission is active: about two or three seconds af-
ter this the green LED of the bound receiver will glow
constantly. If you have not yet bound the receiver to
the transmitter, you can now do so as described on
pages 80 and 88.
Important note:
With the exception of the binding information, all
the receiver’s previously programmed settings
are now reset to the default values. You must
therefore enter the data again if necessary; see
the section entitled “Reset” on page 44.
If you wish to “save” the data, you should run the
program “Receiver Setup” before updating the re-
ceiver. This will spare you the trouble of re-pro-
gramming the receiver under the “Telemetry”
menu.
… 48 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Graupner MX-16 HoTT at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Graupner MX-16 HoTT in the language / languages: English as an attachment in your email.

The manual is 4,49 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Graupner MX-16 HoTT

Graupner MX-16 HoTT User Manual - Dutch - 188 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info