30117
12
Zoom out
Zoom in
Previous page
1/104
Next page
Compatibility of Computer Systems Basics
mc-16/20
12 General Section
The mc-16/20 transmitter can be operated with all
currently available Graupner FM PPM receivers, as
well as other receivers with negative going pulses,
from the 35 and 40 MHz frequency band. Slight
reduction of servo travel can become countered by
the transmitter up to a maximum of ±160%. Also the
neutral position of servos attached receiver channels
1 to 8 can be adapted in ±125 steps, which is
approximately ±70% of normal travel, for all 8
Servos.
In the mc-16/20 Transmitter an FM quartz crystal
(black plastic cap) with corresponding channel
number must be used.
Part No. 3864, or
3264 for the 35 MHz band
Part No. 4064 for the 40 MHz band
Alternatively, the GRUNDIG receiver can be used,
but it is to be made certain that these are equipped
with a GRUNDIG FM quartz (green tab).
A protective plastic film is attached to the input
keyboard of the transmitter, and can be taken off.
Only switch on transmitter with the aerial screwed in,
otherwise it may malfunction and damage the HF
module.
The allocation of the receiver outlets depends on the
type of model selected, and is described on pages
28, 34, 42, 52 and 62.
In order to avoid uncontrolled movements of the
servos attached to receiver outlets, first switch the
transmitter on, then switch on the receiver. After the
relevant operations switch off the receiver, then the
transmitter.
Range Check
With a new model a range test on the ground, with
the transmitter antenna screwed in but not extended,
should be completed before the first flight. The
model should be tested with the engine running and
if available check the fail-safe operation.
Adjustment of the transmitter aerial
In the direction of the extension of the transmitter
antenna, only a small field strength is formed. It is
therefore wrong to point the antenna directly at the
model.
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Graupner MC16 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Graupner MC16 in the language / languages: English as an attachment in your email.

The manual is 16,18 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Graupner MC16

Graupner MC16 User Manual - German - 68 pages

Graupner MC16 User Manual - French - 11 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info