637250
8
Zoom out
Zoom in
Previous page
1/20
Next page
8 - 20
GR-10C_jh_V1
Installation in the model (multicopter)
The receiver must be aligned at right angles to the copter on the
receiver platform. The lower surface of the receiver must always
be parallel to one of the copter sides. Prior to installation, remove
the sticker on the back of the receiver. We recommend using
double-sided tape No.: S8376 for Gr-18 to fix the receiver in
place.
Binding
Binding is only possible if the receiver has not been linked with
a bound transmitter since being switched on (red LED lights). If
you wish to bind the receiver to a new model memory, this is the
procedure:
Switch the transmitter’s RF section off in the “Basic model
settings” menu (see transmitter manual)
Switching the receiver on
Initiate binding in the transmitter’s “Basic model settings”
menu.
If the red LED of the receiver goes out within about 10 sec-
onds and the green LED is illuminated, the binding process
has been completed successfully.
Your transmitter/receiver combination is now ready for oper-
ation.
If the red LED is still lit, the "binding“ failed. In this case,
repeat the whole procedure.
Interfaces
Connect the motors' speed controllers to the receiver's ports
(C1 _ C4). The connectors are reverse polarity protected: note
the small chamfers on the sides. Never use force – the connec-
tors should engage easily. The polarity is also printed on the
receiver; the negative wire (-) is brown, the positive (+) red and
the signal orange. The ports S7 and S8 are switch outputs (see
chapter "Switch function channel 7 and 8")
Attention
The connection scheme is different from HoTT receivers No.
33565 and 33575. Use the adapter No. 33565.1 for the chan-
nel ports, but in this case invert the two external cables signal
and minus. To do it lift lightly the connector holder with a needle
or with a sharpen cutter and pull the cable.
Allocation of the channel ports
CH4
CH1
CH3
CH2
Battery
T/9
S8
S7
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Graupner GR-10C at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Graupner GR-10C in the language / languages: English as an attachment in your email.

The manual is 1,64 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info