747934
9
Zoom out
Zoom in
Previous page
1/36
Next page
9 / 36
S1035_Falcon_12_jh_V1
Binding
The binding is only possible if, since the switch-on of the receiver, it
has not been bound to any transmier (red LED on).
If you want to bind the receiver to a new model memory, proceed as
follows:
Switch o the RF module in the transmiers “Model base set-
ngs” (see transmiers manual)
Distance between transmier and receiver, minimum 1 meter
Switch the receiver on (red LED on), wait about 15 seconds unl
the red LED blinks, the receiver is now in binding mode
Start the binding in the transmiers “Model base sengs”
menu
If the red LED of the receiver switches o within about 15 sec-
onds, the binding process has been concluded successfully. Your
transmier/receiver combinaon is now ready for use.
If the red LED is sll blinking, the binding has not been success-
ful. In this case please repeat the enre procedure.
Interfaces
Connect the servos to the row of sockets on one end of the receiver.
The connectors are reverse polarity protected: note the small cham-
fers on the sides. Never use force the connectors should engage
easily. The polarity is also printed on the receiver; the negave wire
(-) is brown, the posive (+) red and the signal orange. The servo
sockets of Graupner-HoTT 2.4 receivers are numbered sequenally.
The socket for channel 5 can also be programmed to deliver a (digi-
tal) sum signal (see receiver sengs secon).
Aenon
Never connect a baery with voltage higher than 8,4V directly to
the receiver! The receiver and the connected servos would be
destroyed.
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Graupner FALCON 12 - S1035 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Graupner FALCON 12 - S1035 in the language / languages: English as an attachment in your email.

The manual is 12,93 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Graupner FALCON 12 - S1035

Graupner FALCON 12 - S1035 User Manual - German - 36 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info