Manual Gossen Metrawatt Profitest Intro (page 52 of 62) (English)

776259

Zoom out

Zoom in

1/62

52 GMC-I Messtechnik GmbH

17.1 Technical Data for Measurement Cables and Adapters

PRO-Schuko measuring adapter (Z503K) (optional accessory)

300 V CAT III, 16 A

PRO-CH measuring adapter (Z503M) (optional accessory)

300 V CAT III, 16 A

PRO-GB measuring adapter (Z503N) (optional accessory)

300 V CAT III, 16 A

Test probe for remote triggering (Z550A) (optional accessory)

Electrical Safety

KS-PROFiTEST INTRO (Z503L) (scope of delivery)

Measurement cables (black, blue, yellow-green) with test probe

and safety caps and alligator clips for 1000 V CAT III

Electrical Safety, Measurement Cables

Ambient Conditions (EN 61010-031)

Temperature -20 °C ... + 50 °C

Relative humidity Max. 80%

Pollution degree

Application

Attention!

Observe the instrument’s maximum values for electrical safety.

Measurements per DIN EN 61010-031 may only be per-

formed in environments in accordance with measuring

categories III and IV with the safety cap attached to the

test probe at the end of the measurement cable.

In order to establish contact inside 4 mm jacks, the safety caps

have to be removed by prying open the snap fastener with a

pointed object (e.g. the other test probe).

18 Maintenance

18.1 Firmware Revision and Calibration Information

See section 4.5.

18.2 Rechargeable Battery Operation and Charging

Check to make sure that no leakage has occurred at the

rechargeable batteries at short, regular intervals, or after the

instrument has been in storage for a lengthy period of time.

Note

We recommend removing the rechargeable batteries

during lengthy periods of non-use (e.g. vacation). This

prevents excessive depletion or leakage, which may

result in damage to the instrument under unfavorable

conditions.

If rechargeable battery voltage has fallen below the

allowable lower limit, the pictograph shown at the

right appears. “Low Batt!!!” is also displayed along with a

rechargeable battery symbol. The instrument does not function if

the batteries have been depleted excessively, and no display

appears.

Attention!

Use only the Z502R charger in order to recharge the

Compact Master Battery Pack (Z502H) in the test instru-

ment.

Make sure that the following conditions have been fulfilled be-

fore connecting the charger to the charging socket:

– The Compact Master Battery Pack (Z502H) has been

inserted, i.e. not a commercially available rechargeable

battery pack, individual batteries or non-rechargeable

batteries

– The test instrument has been disconnected from the

measuring circuit at all poles

– The instrument must remain off during charging.

If the rechargeable batteries or battery pack (Z502H) have not been

used or recharged for a lengthy period of time (> 1 month), thus

resulting in excessive depletion:

Observe the charging sequence (indicated by LEDs at the char-

ger) and initiate a second charging sequence if necessary (dis-

connect the charger from the mains and from the test instrument

to this end, and then reconnect it).

Please note that the system clock stops in this case and must be

set to the correct time after the instrument has been restarted.

18.2.1 Charging Procedure with the Z502R Charger

➭Insert the correct mains plug for your country into the charger.

Attention!

Make sure that the Compact Master Battery Pack (Z502H)

has been inserted and not a battery holder.

For charging within the instrument, use only the Compact Master Battery

Pack (Z502H) with sealed cells included with the instrument or available

as an accessory.

➭Connect the charger to the test instrument with the jack plug,

and then to the 230 V mains with the interchangeable plug.

(The charger is suitable for mains operation only!)

Attention!

Do not switch the test instrument on during charging.

Monitoring of the charging process might otherwise be

disturbed, in which case the charging times specified in

the technical data can no longer be assured.

➭Please refer to the operating instructions included with the

charger regarding the meanings of LED displays during the

charging process.

➭Do not disconnect the charger from the test instrument until

the green LED (charged/ready) lights up.

Maximum rated voltage 600 V

1000 V

Measuring category

CAT IV CAT III CAT II

Maximum rated current: 1 A 1 A 16 A

With safety cap attached ••—

Without safety cap ——•

Maximum rated voltage 300 V

600 V

1000 V

Measuring category

CAT IV CAT III CAT II

Maximum rated current: 1 A 1 A 16 A

With safety cap attached ••

—

Without safety cap — — •

BAT

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Gossen Metrawatt Profitest Intro in the language / languages: English as an attachment in your email.

The manual is 1.69 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Gossen Metrawatt Profitest Intro Manual

Product: