Manual Giordani Citywave (page 23 of 44) (English, Dutch, French, Italian, Portuguese, Spanish)

769010

Zoom out

Zoom in

1/44

44 45

MATERIALS

Outer lining: 100% polyester

Structure: aluminum

DIMENSIONS

Open: L: 86 cm;

H: 60 cm;

D: 107 cm.

Close: L: 78.5 cm;

H: 60 cm;

D: 41 cm.

WARNINGS

• WARNING Never leave the child unattended.

• WARNING Ensure that all the locking devices

are engaged before use.

• WARNING To avoid injury ensure that the child

is kept away when unfolding and folding this

product.

• WARNING Do not let the child play with this

product.

• WARNING Always use the restraint system .

• WARNING Tenere lontano dal fuoco.

• WARNING Check that the pram body or seat

unit or car seat attachment devices are correct-

ly engaged before use.

• WARNING This product is not suitable for run-

ning or skating.

• WARNING This vehicle is suitable for children

under 3 years old up to 15 kg.

• WARNING The most reclined position is de-

signed for new born babies.

• WARNING To prevent serious injury always use

seat belt.

• WARNING Parking device shall be engaged

when placing and removing the children.

• WARNING Always set both brakes when stroller

is not being pushed.

• WARNING Pay attention the child’s safety when

using the stroller’s moving parts (backrest, rain

cover). Always engage the brake when perform-

ing the above operations.

• WARNING Do not leave the vehicle on a slope

when a child is seated in it, even if the brake is

applied. Brake performance is limited on step

gradients.

• WARNING Do not overload the parcel basket (3

kg). Do not carry parcels and accessories any-

where other than in the basket. It makes stroller

unstable.

• WARNING Any load attached to the handle and/

or on the back of the backrest and/or on the sides

of the vehicle will aect the stability of the vehicle.

• WARNING This stroller is to be used for one

child only.

• WARNING Do not use accessories not approved

by the manufacturer. Only replacement parts

supplied or recommended by the manufacturer/

distributor shall be used.

• No additional mattress shall be added unless

recommended by the manufacturer.

• WARNING Don’t use stroller on escalators or

stairs while child in it, child could fall out.

• WARNING The child should be clear of moving

parts while making adjustments. Be particularly

careful when performing these tasks with the

child nearby.

• WARNING Don’t allow child to hang on the

stroller.

• Regularly inspect all locking devices to ensure

perfect product maintenance. Do not use the

product if breakages or damage of any kind are

found. In product event contact the Retailer or

the Manufacturer immediately. Keep packaging

materials, such as plastic or waterproof wrap-

pings, away from children to avoid suocation.

CARRYCOT

HOOD ASSEMBLY

16. Raise the hood axis as shown in Fig. 16a and

insert the 2 side metal plates on the axis.

The metal plate is mounted correctly when

a CLICK is heard. Before using the carrycot,

try moving the hood with your hands to make

sure it is xedly mounted (see Fig. 16a/16b).

Insert the decorative parts in the base of the

clip as shown in figure 16c. The decorative

clips are mounted correctly when a CLICK is

heard. Before using the carrycot, try moving

them with your hands to make sure each clip

is fixedly mounted. The hood is completely

assembled as shown in Fig. 16d.

FITTING THE LEG COVER

17. As shown in Fig. 17a/17b/17c, rst place the

leg cover on the kit, and then attach the snap

button and fasten with THE Velcro.

HOOD ADJUSTMENT

18. Opening the hood: Open the hood by pushing

it forward as shown in Fig. 18a.

19. Closing the hood: When storing the carrycot,

close the hood as indicated by the arrow (see

Fig. 19a/19b).

ADJUSTABLE HANDLE

20. Unlocking the handle: Pull the handle upward

as indicated by the arrow, it can be adjusted in

three positions. The carrycot is correctly xed

when a CLICK is heard (see Fig. 20).

Locking the handle: Press the buttons on both

sides of the handle bar simultaneously and the

adapter will lock, then push it as indicated by

arrow 2. The handle is securely locked when a

CLICK is heard (see Fig. 20a/20b).

ADJUSTABLE BACKREST

21. Turn the knob clockwise, the backrest can be

raised to the highest position at 165°. Turn

the knob counter-clockwise and push down

slightly: this way the backrest can be lowered

(see Fig. 21a/21b/21c).

ACCESSORIES

22. Preparation before use: First mount the large

buckle on the carrycot. Fix "hole a" to the xed

plastic element b, insert and push the large

buckle at the same time downwards as indicat-

ed by arrow 2 (see Fig. 22a/22b). Repeat the op-

eration also for the other buckle of the carrycot.

23. Pay attention to the various operations when

the seat is used in the car, see Fig. 23a/23b.

24. Fitting the carrycot in the car: M

ount the

carrycot in the position shown in Fig. 23a/23b. Insert

the car’s security slot into the buckle on the seat and

push out the seat belt (see Fig. 24a/24b); create an

eyelet with the strap, pass the eyelet in the hole of

the metal connector of the car and pass it on the tab

of the connector as indicated in Fig. 24c/24d; tighten

the seat belt as indicated by the arrow (see Fig. 24e).

Repeat the operation also for the other buckle. In this

way the carrycot is permanently mounted in the car as

indicated in Fig. 24f/24g.

25. Removing the carrycot from the car:

As shown in Fig. 25a, the carrycot can be

disassembled from the car by releasing the

large buckle (see arrow). Large buckles can

be fastened to the seat belt after removing

the carrycot from the car (see Fig. 25b).

Note: The carrycot can only be mounted on

the rear seat and always in the direction of

travel. It can be mounted in vehicles equipped

with a 3-point static belt in compliance with

the R6 ECE/EEC standard.

WARNING

26. For safety reasons, never place the child's

head facing the door. Once the carrycot is

mounted in the back seat, for the child's safety

make sure that the carrycot restraint system is

securely fastened, especially if you are travel-

ling. After tting the carrycot on the back seat,

adjust the backrest to the lowest position and

lower the transport handle. When installed in

the rear seat, the seat belts that hold the car-

rycot's restraint system to the vehicle must be

securely tightened. Adjust the seat belt to its

maximum length to ensure the stability of the

carrycot when used in the car. Adjust the seat

belt to keep the carrycot stable in the vehicle,

the belt must be tight and never twisted.

USE OF SAFETY BELTS IN THE CAR

27. If the carrycot is used as a car seat, press the

centre button to open the buckle, see Fig. 27a.

Connect the buckle to both sides, the buckle

can be xed, see Fig. 27b.

Note: Always use the seat belt when the child

is in the carrycot.

USE OF SAFETY BELTS OUTSIDE THE CAR

28. When using the carrycot outside the car, the

seat belts must be hidden. Remove the reduc-

er by removing the belt from the eyelets (Fig.

28a). Remove the two ends of the belt from

the mattress by passing the buckles into the

corresponding eyelets (Fig. 28b). Place the

two ends of the belt towards the foot area of

the carrycot (Fig. 28c). Reposition the mat-

tress so as to cover the two ends of the belt.

For use in cars the steps must be repeated in

reverse order to make the belt usable.

USE OF THE BREATHING HOLE

29. Opening the ventilation hole: Turn the knob

under the basket anti-clockwise, the breathing

holes will open. The ventilation function is now

enabled with all the holes facing up.

30. Closing the ventilation hole: Turn the knob

under the basket clockwise, the breathing holes

will close (see Fig. 30a/30b). There will be no

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Giordani Citywave in the language / languages: English, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 5,65 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Giordani Citywave Manual

Product: