Operating instructions Geberit AquaClean 8000plus
23
Shower water temperature is
too low
Heating element is not switched
on
Use the remote control to switch
the <water heater function> ON
Warm-up time too short when
heating element is in economy
mode
Use the remote control to switch
the <water heater function> ON
Software error Switch the power switch off and
back on again after 30 s
Odour extraction unit does
not start
Automatic start of the odour
extraction unit is deactivated
Switch on the odour extraction
unit at the control panel
Shower spray is too weak or
no water is spraying out at all
Spray intensity is set too low Increase the spray intensity
Spray nozzle clogged or blocked
with limescale
Clean or replace the spray nozzle
Spray arm does not retract Power supply interrupted Restore the power supply. The
spray arm will retract
automatically
Shower toilet is defective Switch off the shower toilet and
contact customer service
Dryer does not start Automatic dryer start is switched
off
Switch on the dryer at the control
panel
Low dryer output Dryer arm installed the wrong
way round
Install the dryer arm correctly
Dryer arm does not retract
fully
Dryer arm is not clipped in Clip the dryer arm into the guide
Lowering function not
working
Hydraulics are defective Contact customer service
Left and right hinges are not
closed
Close hinges fully
Unpleasant odour in spite of
the odour extraction unit
Active carbon filter is spent Replace the active carbon filter
(art. no. 250.022.00.1)
Rattling noise after use Nozzle cleaner tank is empty Check the filling level and top up
the nozzle cleaner tank with
nozzle cleaner (art. no.
250.028.00.1)
Water is continuously
dripping into WC ceramic
appliance
Flush valve system is leaky Contact customer service
Malfunction
MalfunctionMalfunction
Malfunction Cause
CauseCause
Cause Fault clearance
Fault clearanceFault clearance
Fault clearance
