813484
17
Zoom out
Zoom in
Previous page
1/48
Next page
17
SAFETY PRECAUTIONS
IMPORTANT: ALWAYS WEAR THE GLOVES
PROVIDED WHEN HANDLING AN IVORY PAINTED
APPLIANCE.
For your own and other’s safety, you must install this appliance
according to local and national codes of practice. Failure to install
the appliance correctly could lead to prosecution. Read these
instructions before installing and using this appliance.
These instructions must be left intact with the user.
Do not attempt to burn rubbish on this appliance.
Keep all plastic bags away from young children.
Do not place any object on or near to the appliance and allow
adequate clearance above the appliance.
IF THE APPLIANCE IS EXTINGUISHED OR GOES OUT IN USE,
WAIT 3 MINUTES BEFORE ATTEMPTING TO RELIGHT THE
APPLIANCE.
The appliance is fitted with the Gazco Flue Sure System, which will
act to cut off the gas supply to the burners in the event of incorrect
operation of the flue. If the system acts to cut off the gas supply,
this indicates that there is insufficient flue pull. If this occurs a
minimum of 10 minutes should be allowed before trying to relight.
Continued operation of this safety device means there may be a
serious problem with the flue system. A qualified GasSafe engineer
should inspect this.
Do not alter or tamper with the Flue Sure System. Use only
genuine Gazco replacement parts when servicing the system -
refer to the Servicing Section, Replacing Parts.
DO NOT USE THE APPLIANCE UNTIL AN ENGINEER SAYS IT
IS SAFE TO DO SO.
IMPORTANT: REFER TO DATA BADGE AND
TECHNICAL SPECIFICATION AT THE FRONT OF
THE MANUAL TO ENSURE THE APPLIANCE IS
CORRECTLY ADJUSTED FOR THE GAS TYPE AND
CATEGORY APPLICABLE IN THE COUNTRY OF
USE.
UNPACKING
Remove the appliance from its packaging, and check that it is
complete and undamaged.
Put the loose ceramic parts to one side so that they are not
damaged during installation.
UPGRADING THE APPLIANCE
The appliance is fitted with a control valve that can easily be
upgraded to battery powered remote control.
There are two versions of this control which can be obtained
through your local Gazco retailer.
There is no requirement for this upgrade to be carried out by an
approved GasSafe engineer. However Gazco recommend that this
task is undertaken by a suitably competent person.
This upgrade can be fitted before or after installation but if side
clearances are limited then it will be easier to upgrade the
appliance before installation. Full instructions are included with the
kit.
If the appliance is left unattended for long periods of
time (e.g. vacation), it is recommended to place the
control valve in the Off or Pilot position.
Take care when leaving the appliance unattended,
in exceptional circumstances sound waves from
sources other than the transmitter can cause
changes in the ame height adjustment.
DO NOT install two or more appliances using
upgradeable controls in the same room, interference
between the remote control frequencies can occur.
STANDARD REMOTE CONTROL
(PART NUMBER 8455)
This remote control can control the gas appliance after the pilot
has been lit. It can turn the main burner on and regulate it from low
through to high and back again.
It can turn the main burner off leaving the pilot burning.
THERMOSTATIC AND TIMER REMOTE CONTROL
(PART NUMBER 8456)
This remote control can control the gas appliance after the pilot
has been lit.
MANUAL MODE
Can be used to turn the main burner on and manually regulate it
from low through to high and back again. It can also be used to
turn the main burner off leaving the pilot burning.
AUTO MODE
Will automatically regulate the room to a pre-set temperature.
TIMER MODE
Will turn the appliance on and off according to a pre-set
programme and automatically regulate the room temperature
during the two on periods.
INSTALLATION
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gazco Huntingdon 20-30-40 - Conventional Flue at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gazco Huntingdon 20-30-40 - Conventional Flue in the language / languages: English as an attachment in your email.

The manual is 13.82 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info