813484
18
Zoom out
Zoom in
Previous page
1/48
Next page
18
INSTALLATION OF THE APPLIANCE
Decide whether to use top or rear flue exit.
The appliance is factory built for rear flue exit but it can be
changed to top exit by swapping the flue spigot and blanking plate
located on the appliance.
HUNTINGDON 30 ONLY
On Huntingdon 30 models the flue spigot must be placed in an
offset position from the blanking plate to correctly align with the top
plate.
To access the blanking plate lift off the cast top and place carefully
to one side.
Remove the four screws holding the blanking plate to the
appliance.
Note the two additional holes in the top of the firebox.
With the blanking plate removed there are a two additional holes
underneath.
Position the flue spigot using the offset holes and the ones
previously beneath the blanking plate. Secure the spigot and
blanking plate in the new positions.
ALL MODELS
Position the appliance ensuring all appropriate clearances are
observed.
Having run the gas supply to the appliance PURGE THE SUPPLY
PIPE.
This is essential to expel any debris that can block the gas
controls.
Connect the gas supply to the 8mm compression elbow at the
right-hand rear corner of the appliance.
There is a cutout in the right-hand rear leg to enable a straight
connection to the rear of the appliance.
The flue system can now be connected to the appliance.
Ensure all joints are sealed with a fire resistant cement and use a
self-tapping screw at the flue spigot joint.
GAS SOUNDNESS PRESSURE CHECK
Connect a suitable pressure gauge to the test point located on the
inlet fitting and turn the gas supply on. Light the appliance and
check all gas joints for possible leaks. Turn the appliance to
maximum and check that the supply pressure is as stated on the
databadge. Turn the gas off and replace the test point screw, turn
the gas on and check the test point for leaks.
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gazco Huntingdon 20-30-40 - Conventional Flue at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gazco Huntingdon 20-30-40 - Conventional Flue in the language / languages: English as an attachment in your email.

The manual is 13.82 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info