Filling Chain Oil
1. Unscrew the cap of the oil tank (10) and fill in suitable chain oil.
2. Wipe the tank clean and close the oil tank with the cap.
Hints:
Do not operate the pole saw without sufficient chain lubrication.
Insufficient lubrication will shorten the service life of the saw chain
and the guide bar.
The gardening tool is equipped with automatic oiling mechanism.
As soon as the motor is running, the oil flows to the guide bar.
Regularly check the oil level in the tank and re-fill with oil in time.
Only use biodegradable chain oil (e.g. Westfalia Biological
Adhesive, article number 76 63 78). Pour the chain oil into the oil
tank. Do not use motor oil or other mineral oils.
Clean the filler cap and the area around it to avoid contaminating
the oil tank.
If the oil level in the tank does not drop, the oil duct in the housing
and the guide bar may be clogged. Check and clean it as needed.
Caution! The saw can re-oil. Please note that the saw re-oils after
use and oil may leak out if it is stored on its side or on the head.
This is a normal process.
Checking the Chain Lubrication
Hold the running chain saw about
15 cm over a suitable surface for a few
moments. If the oil thrown from the
chain forms a slight track on the
surface the lubrication is sufficient.
Do not use the pole saw if the lubrication is insufficient.
Operation
Observe the country-specific and local authority regulations. Do not
work during commonly accepted or mandatory rest periods.
Before starting the gardening tool, check:
