584000
54
Zoom out
Zoom in
Previous page
1/124
Next page
Page 4-18 400 SERIES INSTALLATION MANUAL
Page Rev L P/N 190-00140-02
4.9 RMI/OBI
4.9.1 RMI/OBI Function
The MAIN OBI output provides bearing information from the active waypoint for Bendix/King Serial OBI
devices based upon the 400 Series unit’s GPS navigation. For the GNS 430, the MAIN OBI output may be
configured so that it sends VOR/ILS bearing information when VLOC is selected by the GNS 430 CDI
key.
The VOR OBI output provides bearing information from the active waypoint for Bendix/King Serial OBI
devices based upon the GNS 430 VOR receiver.
When a localizer channel is tuned on the VLOC window, there is a bit in the data stream set to indicate that
a localizer frequency is tuned which stows the needle or drives it to the 3 o’clock position.
4.9.2 RMI/OBI Electrical Characteristics
Pin Name Connector Pin I/O
MAIN OBI CLOCK P4001 43 Out
MAIN OBI SYNC P4001 45 Out
MAIN OBI DATA P4001 44 Out
Pin Name Connector Pin I/O
VOR OBI CLOCK P4006 25 Out
VOR OBI SYNC P4006 26 Out
VOR OBI DATA P4006 27 Out
The output driver is active low. The driver output voltage is not more than 1.0 V when sinking 20 mA
DC
.
The maximum off state leakage current with respect to ground is less than 10 µA
DC
.
4.9.3 RMI/OBI Configuration
For the GNS 430, refer to section 5.2.10 for the MAIN OBI source configuration.
4.9.4 RMI/OBI Calibration and Checkout
None.
4.9.5 RMI/OBI Interconnect
Refer to Figure 4-22 on page 4-63 for the RMI/OBI interconnect.
54


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Garmin GNC 420 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Garmin GNC 420 in the language / languages: English as an attachment in your email.

The manual is 4,43 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info