724645
10
Zoom out
Zoom in
Previous page
1/19
Next page
24.5cc 4 Stroke Petrol Blower Vacuum
AFTER SALES SUPPORT
e-mail: help@powertoolsupport.com
1800 909 909
MODEL: №. EBV245A • 08/2018 • 52754
(toll free)
AFTER SALES SUPPORT
(toll free)
24.5cc 4 Stroke Petrol Blower Vacuum
e-mail: help@powertoolsupport.com1800 909 909
MODEL: №. EBV245A • 08/2018 • 52754
16 17
Fitting the Vacuum Tube to the
Blower Vacuum Housing
1. Loosen and remove the intake cover lock screw
(29) on the intake cover (8) by turning in an anti
clockwise direction (Fig H).
2. Open the intake cover (8) and insert the lower
vacuum tube (9) so it ts inside the round
entry of the vacuum housing by aligning the
external pins protruding from the port with the
2 channels on each side of the upper vacuum
tube (9) (Fig I).
3. Push the tube assembly onto the port as far as it
will go, and then rotate the lower vacuum tube
(9) in a clockwise direction until it can be rotated
no further. The tube should now be suciently
locked in place and ready for use.
NOTE: The intake cover lock screw (29) is not re-
applied when the unit is in vacuum mode. Ensure
you keep the lock screw (29) in a safe place for
when required to re-apply when the product is
used in blow mode.
Fitting the bag tube and collection bag.
WARNING: Never operate the vacuum without
collection bag attached.
Serious personal injury could be the result if the
blower vacuum is used without the bag tted.
IMPORTANT: Before using this product as a
vacuum, ensure the correct vacuum tubes are in
position as per the instructions on the previous
page, and the collection bag zip is done up before
tting.
1. Align the arrow on the bag tube (7) with the
arrow on the discharge port (24) and rotate the
bag tube (7) in a clockwise direction as far as it
will go until you can see the screw hole on the
discharge port (24) through the bag tube (7)
(Fig J).
2. Secure the assembly screw using the supplied
spark plug spanner / combination screwdriver
(25) rotating in a clockwise direction until
secure (Fig K).
3. Undo the velcro strip on the collection bag (10)
and place the small opening end of the bag
over the open end of the bag tube (7)
and secure the bag over the bag tube (7) by
re-securing the velcro strip (Fig L).
NOTE: the bag can be rotated on the tube later
to nd the most comfortable position.
4. When you start using the unit as a vacuum,
place the shoulder strap attached to the bag
over your shoulder to balance the collection
bag while lling.
I.
H.
LOOSEN
LOCK IN PLACE
Assembly Assembly
J.
K.
L.
TIGHTEN
LOCK IN PLACE
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gardenline EBV245A at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gardenline EBV245A in the language / languages: English as an attachment in your email.

The manual is 0,88 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info