724645

Gardenline EBV245A Manual

11
Zoom out
Zoom in
Previous page
1/19
Next page
24.5cc 4 Stroke Petrol Blower Vacuum
AFTER SALES SUPPORT
e-mail: help@powertoolsupport.com
1800 909 909
MODEL: №. EBV245A • 08/2018 • 52754
(toll free)
AFTER SALES SUPPORT
(toll free)
24.5cc 4 Stroke Petrol Blower Vacuum
e-mail: help@powertoolsupport.com1800 909 909
MODEL: №. EBV245A • 08/2018 • 52754
18 19
4. Clean the dipstick portion of any oil residue and
then insert the dipstick fully into the oil reservoir,
however, DO NOT THREAD the dipstick into the
reservoir. Hold the dipstick in place for a few
seconds and then remove (Fig O).
5. Check the oil mark on the dipstick. It should reach
the middle hole on the dipstick. Be careful not to
overll (Fig P).
6. If the oil level is not close to the middle hole,
then add small amounts of oil and repeat steps 3, 4 & 5 until the oil level is
approaching the middle hole on the dipstick.
DO NOT OVERFILL. Do Not EXCEED the upper hole on the dipstick.
7. IMPORTANT: The motor should NEVER be started if the oil level is below
the lowest hole.
Always check the oil level before starting ensuring the blower vacuum is
positioned as per step1 for checking.
8. When the oil level reaches the middle hole, replace the dipstick (14) and
thread in the dipstick in a clockwise direction until the dipstick is rmly in
place. The Sealing O ring on the shoulder of the dipstick should be fully
compressed when the dipstick is rmly hand tightened.
Adding and Checking the oil
IMPORTANT: The motor of this blower vacuum is packed with NO OIL in
the motor. Prior to starting the motor, 4 stroke oil MUST be added to the oil
reservoir (14). Failure to add sucient oil will result in damage to the motor
which is NOT covered under the warranty of the unit.
NOTE: This is a 4 stroke blower vacuum. The motor sump MUST be lled with
60mL of 4 stroke SAE 10W/30 BEFORE starting. Fresh unleaded fuel must be
used in this unit. Do not use ethanol based fuels.
Do NOT mix oil with fuel. Oil must be separately poured into the sump of
the motor as follows, and also the oil level MUST be checked every time the
blower is used.
NEVER attempt to remove the oil dipstick (14) while the motor is running.
ENSURE the motor is not running when the oil level is being checked.
On a new unit, the motor needs to be lled with 60mL of SAE 10W/30
engine oil.
To initially ll with oil or to check the oil level, follow the process below.
1. Sit the blower on its side such that the intake cover is resting on a secure
at surface, or on the ground, and the oil reservoir is easily accessible
(Fig M). Clean the area directly around the oil reservoir (14) (Fig N).
2. Fully remove/unthread the oil dipstick in an anti clockwise direction.
3. On a new unit which has not previously been lled with oil, measure 60mL
of SAE 10W/30 oil
and pour into the oil
reservoir (14), using
a funnel, where the
dipstick was removed.
O.
N.M.
P.
CORRECT
LEVEL
(MIDDLE HOLE)
DO NOT
OVERFILL
(TOP HOLE)
Preparation Preparation
Preparation
… 11 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gardenline EBV245A at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gardenline EBV245A in the language / languages: English as an attachment in your email.

The manual is 0,88 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info