782039
26
Zoom out
Zoom in
Previous page
1/53
Next page
Now remove the wedge you have cut out.
Afterwards, you can carry out the dropping cut on the opposite side of the tree
(Pos. 4). For this, start about 5cm above the middle of the cut. In this way, there
is enough wood between the dropping cut (Pos. 4) and the wedge (Pos. 2) so
that it functions as a hinge. This hinge is designed to guide the tree in the right
direction when falling.
m NOTICE
Before completing the dropping cut, if required, increase the cut using wedges to
control the direction of the fall. Exclusively use wood or plastic wedges. Steel or iron
wedges can cause kickback and damage to the device.
Be aware of signs that the tree is beginning to fall: Cracking sounds, the
dropping cut opening or movement in the upper branches.
When the tree begins to fall, stop the saw, put it down and leave immediately
via your escape route.
To prevent injuries, do not cut partly felled trees with your saw. Beware
especially of partly felled trees which are not supported. If a tree does not fall
down completely, remove the saw and help the process along with a cable
winch, a pulley or a towing vehicle.
Sawing a felled tree (log division)
The term „log division“ describes the cutting up of a felled tree into logs of the
desired length.
m CAUTION
Do not stand on the log you are currently cutting. The log could roll away and you
may lose your footing and control of the device. Do not carry out sawing work on
sloping ground.
Important notices
Only ever saw one log or branch.
Be careful when cutting split wood. You may be hit by sharp pieces of wood.
Cut small logs or branches on a sawhorse. When cutting logs, no other person
must hold on to the log. Do not secure the log with your leg or foot.
Do not use the saw in areas where logs, roots and other parts of the tree are
entangled. Pull the logs to a free area and cut the freed logs rst.
30 AFTER SALES SUPPORT
aldi.service.uk@scheppach.com 00800 4003 4003
MODEL: CSP41 PRODUCT CODE: 64055 04/2017
Safety regulations Petrol chainsaw 41cc
26


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gardenline CSP41 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gardenline CSP41 in the language / languages: English as an attachment in your email.

The manual is 6.97 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info