441948

G-rail 6200 Manual

11
Zoom out
Zoom in
Previous page
1/28
Next page
3
Removing ALL RF channels
(individual channels cannot be removed)
Removing all RF channels is also a timed procedure: Please read all steps before proceeding.
STEP 1
Press and hold button (A) on the receiver.
STEP 2
With the button (A) pressed, the LED (B) will light up, then goes out and
then flashes 3 times.
STEP 3
Release button (A) exactly during the third flash. The LED will flash 5
times to confirm that ALL channels have been removed.
Transmitter button functions
Initially either button can provide Open or Close function.
Functions of OPEN and CLOSE buttons:
- Keeping ‘open’ or ‘close’ button pressed for more than 1 second: the
system will run until the button is released.
- briefly press and release either button, less than 1 second: the system
will run until an end-position is reached or until the button is again briefly
pressed and released.
Functions of STOP button :
- pressed briefly and released: the system stops if running.
- keep the button pressed longer: the motor unit enters programming
mode.
Programming curtain end-positions of 6200/6500 systems
Programming of the end-positions is now required. Only where ‘pre-fix
20’ is shown on the silver motor identification label can series 6200 and
6500 be programmed using RF transmitter. The end-positions are stored
in the motor unit and are independent from the RF channels.
1) First remove all power plugs and data leads from the motor units of systems
already connected - as well as all other systems within reach of the RF transmitter
(35 metres indoors). Connect an RF receiver to the motor unit and ensure an
RF channel is set in the receiver (see above). End positions can be set only with
previously set RF channels. Connect power supply to the motor
2) If during the following proceedure no operating instructions have been
transmitted (within 1 minute), the motor unit will automatically exit programming
mode: the motor unit LED will go out, return to step 1.
AB
!
FR
DE
NL
EN
… 11 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for G-rail 6200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of G-rail 6200 in the language / languages: Dutch as an attachment in your email.

The manual is 1,62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info