781824

Fuxtec FX-SG7500B Manual

39
Zoom out
Zoom in
Previous page
1/87
Next page
Original User Manual Generator FX-SG Series
38
◼ Unscrew the oil filter cup.
◼ Blow out the oil filter cup thoroughly
with compressed air against the
direction of the arrow.
◼ Place new rubber sealing ring on
sealing surface of oil filter cup and
screw oil filter cup back in.
Troubleshooting
The engine will not start.
◼ Check whether the on/off switch or the
key switch (for generators with electric
starter) is in the operating position -
"ON" position.
◼ Check the engine oil level. If the oil
level is too low, the engine cannot be
started.
◼ Check if there is fuel in the fuel tank.
◼ Disconnect the spark plug connector,
remove the spark plug with the spark
plug wrench and check its condition.
− Use a wire brush to remove soot
particles from the spark plug and
electrodes.
− Check the electrode gap and adjust
it to 0.7 to 0.8 mm if necessary.
The generator does not produce
any current.
◼ Connect a hand lamp to the generator
to check.
◼ Check that the AC fuse switch is in
the "ON" position.
CAUTION!
Observe:
If the generator still does not start 0or does
not generate power, contact your dealer or
an authorized service shop for further
troubleshooting.
Cleaning instructions
Neglecting cleaning measures may lead to
material damage and malfunctions.
Do not spray the power generator
with water.
◼ Keep ventilation slots clean and free of
dust.
◼ Use a soft cloth and a soft brush for
cleaning the exterior.
◼ Clean the tank cover seals regularly
and replace them if necessary.
Storage
NOTE!
Always store the power generator in a
clean, dry, and frost-free place.
If the current collector is to be stored for a
more extended period, proceed as follows:
◼ Shut off fuel tap and unscrew oil filter
cup counterclockwise, drain and blow
out clean.
◼ Position a suitable drain container under
the drain, open the fuel tap, and drain
the fuel entirely into the box.
◼ Replace a sealing ring (rubber) and
screw the oil filter cup back in
clockwise.
◼ Loosen carburettor drain plug and drain
residual fuel from the carburettor into a
suitable container. Tighten carburettor
drain plug again.
◼ Unscrew the oil filler cap, unscrew the
oil drain plug and completely drain oil
from the crankcase into a suitable
container.
◼ Retighten the oil drain plug and fill it
with suitable engine oil up to the
dipstick's upper mark. Screw the oil
filler cap back into the oil filler neck.
Pull until resistance is felt.
◼ Pull the starter rope in doses until
resistance is felt.
CAUTION!
Keep the power generator clean.
… 39 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fuxtec FX-SG7500B at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fuxtec FX-SG7500B in the language / languages: English, German, French, Italian as an attachment in your email.

The manual is 4.39 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info