450995

Futaba T10 CAG Manual

44
Zoom out
Zoom in
Previous page
1/119
Next page
44
GOAL of EXAMPLE: STEPS: INPUTS:
Set up aileron triple rates on SWITCH
C with travel settings of 75% (normal),
25% (slow roll) and 140% (extreme
aerobatics) and exponential settings of
0%, +15%, and -40% respectively.
NOTE: This normal rate has no
exponential so it has a very linear,
normal feel. This slow roll rate has
positive exponential (the opposite of
what most people normally use), which
makes the servos more responsive
around center. This makes the servos
feel the same around center in the
normal and low rates, but still gives a
very slow roll rate at full stick.
The 3D rate (extreme aerobatics) has a
very high distance of travel nearly twice
that of the normal rate. Therefore, using
a very high negative exponential setting
softens how the servos respond around
center stick. This makes the servos
respond similarly around center stick
for a more comfortable feel.
Many modelers like to set up all 3 triple
rates on a single 3-position switch,
creating a “slow and pretty mode”,
a “normal mode”, and a “wild stunts
mode” all with the flip of a single
switch. To do so, simply set up rates
for all 3 controls and assign all 3 to the
same 3-position switch.
Open
D/R
,
EXP
function.
for 1 second.
(If
ADVANCE
, again.)
C
to
D/R
,
EXP
.
Choose the channel to change
(Ex: aileron is already selected)
C
to desired channel.
Optional: change switch assignment.
C
to
SW1
. to
C
.
Confirm switch is in desired position
and set rate. (Ex: up = high rate, 75%).
C
to
D/R>
.
C to up position.
AILERON STICK. to 75%.
AILERON STICK. to 75%.
Move SWITCH to 2nd rate position and
set this particular rate.
(Ex: center = low rate, 25%).
C to center position.
AILERON STICK. to 25%.
AILERON STICK. to 25%.
Optional: if using a 3 position SWITCH,
move SWITCH to 3rd position and set
this rate (Ex: down = 3D rate, 140%).
C to down position.
AILERON STICK. to 140%.
AILERON STICK. to 140%.
Optional: instead of using a switch,
you can set high rates to be triggered
when the stick moves past a certain
point. To test this, set aileron high rate
to 25%. Now set switch assignment to
AIL (90%). Move AILERON STICK
to the right and notice the huge jump in
travel after the stick moves 90% of its
distance.
C
to
SW1
. to
AILE (90%)
.
C
to
D/R>
.
AILERON STICK. to 25%.
AILERON STICK. to 25%.
AILERON STICK and watch
screen graph. See the change?!
You may also change the trigger point
by holding the stick at the desired point,
then pressing and holding the DIAL.
Set each rate’s
EXP
.
(Ex: 0%, +15%, -40%)
C
to
EXP>
.
C to up position.
&RQ¿UP
EXP
reads 0.
C to down position.
AILERON STICK. to +15%.
AILERON STICK. to + 15%.
C to center position.
repeat to set low rate expo to -40%.
Repeat above steps for elevator and rudder.
Close.
Where next? 6HWXSÀLJKWWLPHUVVHHS
Set up
TRAINER
functions: see p. 47.
Adjust the sensitivity of the trims: see p. 48.
Set up twin aileron servos: see p. 51.
Set up twin elevator servos: see p. 57.
6HWXSSURJUDPPDEOHPL[HVWRPHHW\RXUVSHFL¿FQHHGVVHHS
… 44 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Futaba T10 CAG at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Futaba T10 CAG in the language / languages: English as an attachment in your email.

The manual is 2,73 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info