30094

Futaba FP8SSAP Manual

22
Zoom out
Zoom in
Previous page
1/44
Next page
ADJUSTMENTS AND FLIGHT TECHNIQUES
•USING
DUAL
RATE
(AILERON, ELEVATOR, AND RUDDER)
Dual rate functions allow the flyer to alter the
maximum servo travel (and therefore control sensi-
tivity) during flight by using the appropriate rate
switch. At D/R OFF, servo deflection is maximum
in both directions (unless limited by ATV set-
tings). At D/R ON, servo deflection is reduced by
a percentage set with the D/R trimmers. Dual rate
adjustments always effect both directions of servo
travel.
AILERON DUAL RATE
• The aileron rate switch 14 has two D/R ON positions. Thus three different servo travel rates are available
on aileron. Rates can be adjusted to suit varying aircraft and maneuver requirements.
1 Aileron dual rate trimmer (I)
This trimmer sets the aileron travel when the aileron dual rate switch 14 is set
to the dual ON I position.
2 Aileron dual rate trimmer 2
(Switch in LINEAR Position)
Dual rate switch OFF
This trimmer sets the aileron travel
when the aileron dual rate switch
14 is set to the dual ON 2 posi-
tion.
Servo
throw
Trimmers [1] and [2] can adjust the
aileron travel from 40% to 80% of
the total travel.
When the dual rate switch is set to
ON, the servo throw can be set to
an arbitary angle smaller than
when the dual rate switch is OFF
(normal) as shown in Fig. 27. Use
the throw matched to the aircraft
and the maneuvers to be perform-
ed.
Stick deflection
When the dual rate switch
is ON, the servo throw can be
adjusted within this range with
the dual rate trimmers.
N
3 LINEAR ->VTR selector
This switch linearly switches the
aileron servo when the aileron dual
rate switch 14 is in the OFF posi-
tion.
Fig.
26
Fig.
27
ELEVATOR DUAL RATE RUDDER DUAL RATE
20
Fig.
28
23 Elevator dual rate trimmer
This trimmer sets the elevator
deflection angle when the el-
evator dual rate switch 15 is
in the ON position. It has the
same functions as (A) aileron
dual rate I .
24 LINEAR ->VTR selector
This switch changes the eleva-
tor servo operation linearity
when the selector dual rate
switch 15 is in the OFF po-
sition. It has the same func-
tions
as
(A) aileron dual
rate(I),
21 Rudder dual rate trimmer
This trimmer sets the rudder
deflection angle when the
rudder dual rate switch 16 is
in the ON position. It has the
same functions as (A) aileron
dual rate I .
22 LINEAR -> VTR selector
This switch changes the rud-
der servo operating linearity
when the rudder dual rate
switch 16 is in the OFF po-
sition. It has the same func-
tions
as
(A) aileron dual
rate(I).
Fig.
29
… 22 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Futaba FP8SSAP at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Futaba FP8SSAP in the language / languages: English as an attachment in your email.

The manual is 2,23 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info