30094
17
Zoom out
Zoom in
Previous page
1/44
Next page
•RECEIVER AND SERVOS
Receiver, Servo Switch, and
Battery Connections
Fig. 15
NR-4J
Charging plug
Power switch
SWH-5 (R4-SWJ)
Pitch
control
servo
1
5
Spoiler
servo
Flap servo
Landing gear servo
Landing gear servo
AEC-A
Landing gear adaptor
PCM receiver
FP-R118GP
Extension cord
AEC-3
Antenna wire
Rudder servo
Throttle servo
Elevator servo
Aileron servo
Pay careful attention to the polarity
of the connector.
8SSAP 4 Servos
PCM RECEIVER FP-R118GP
crystal
Fig.
17
Error lamp
•This LED comes on when the
receiver operated erroneously.
When the receiver and servo side
Nicd is connected and this LED
is on, radiowaves are not being
received from the transmitter,
check to be sure the frequency
is correct. Checking is possible
by the lamp being on.
•When strong noise has
been
received, or the radiowaves from
the transmitter are intermittent-
ly interrupted, this lamp will blink.
This is usually not a problem.
Remove the receiver
crystal by pulling it in
this direction.
Receiver crystal
Fig. 18
Antenna
wire
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Futaba FP8SSAP at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Futaba FP8SSAP in the language / languages: English as an attachment in your email.

The manual is 2,23 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info