30030

Futaba FP7FGH Manual

7
Zoom out
Zoom in
Previous page
1/16
Next page
• OPERATION
This section explains the operation of the trans-
mitter controls when the servo reversing switch-
es are in the normal position. When the revers-
ing switches are in the reverse position, opera-
tion is the opposite of that described here.
CD Aileron stick Controls the ailerons.
2
Elevator stick Controls the elevators.
3 Throttle Stick Controls the throttle.
4 Rudder Stick Controls the rudders.
5 CH5 switch Switches the rate gyro output.
6 Pitch trimmer/CH6 lever Trims the pro-
peller pitch control independently from the
throttle.
(7)CH7 lever Spare channel.
8 Aileron trim lever Aileron trimmer.
9
Elevator
trim
lever
Elevator
trimmer.
10
Throttle
trim
lever
w/ATL
Adjustable
travel
trim
lever. This
lever
acts
as
a
trimmer
only when the throttle stick is at the low side as
shown in Fig. 6. It is very convenient because
the high side of the throttle position remains
unchanged even when the low side is adjusted.
Servo throw by
throttle stick
Servo throw by
throttle trimming
(30% of total
travel)
12
Aileron dual rate switch Aileron dual
rate ON-OFF switch. When set to the upper po-
sition, dual rate is turned on, and when set to
the lower position, dual rate is turned off. At
dual ON. the deflection can be set as shown in
Fig. 7 with the aileron dual rate trimmer
located on the trimmer panel at the back of the
transmitter. At dual OFF, the operating linearity
can be switched as shown in Fig. 8 with the
VTR (Variable Trace Ratio) switch also located
on the trimmer panel.
Deflection is
adjustable
from 40% to
100%
of
the
total travel
within this
range.
Neutral
Aileron servo
Fig.
7
DR side VTR side
N
Stick deflection N Stick deflection
Fig.
8
11 Rudder trim lever Rudder trimmer.
5
Fig.
6
*Trim lever is used for fine adjustment.
The trim lever is used for neutral position adjustment or correction of the posture of the aircraft after
installation is completed. However, after test flight, try to keep the neutral position as they are mak-
ing necessary corrections with the rod adjusters, etc.
… 7 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Futaba FP7FGH at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Futaba FP7FGH in the language / languages: English as an attachment in your email.

The manual is 2,54 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info