29051
5
Zoom out
Zoom in
Previous page
1/12
Next page
•THROTTLE STICK NEUTRAL LEVER OPERATION
•The
neutral position of the throttle stick (engine
control
stick)
at
the
left
side
can be
selected
in
two
stages
by
moving
the neutral lever as shown in the figure.
When neutral
lever up
When neutral
lever down
If the neutral lever is moved, the
neutral position of the stick
lever can be adjusted in two
steps as shown in the figure.
When the neutral lever is up, the
throttle stick can be adjusted to
a total of 54°, 27" up and 27°
down, from the neutral posi-
tion. This position is best for
electric cars and other models
with which the center of the
speed controller is the neutral
position.
When the neutral lever is down,
the throttle stick can be ad-
justed to a total of 54°, 36° up
and 18° down (2-to-1), from the
neutral position. This position is
best for engine-drive cars or
other models with which the
speed controller neutral position
is offset.
•CHANGING THE THROTTLE STICK FROM A
SELF NEUTRAL SYSTEM TO A RATCHET
SYSTEM
•When changing the throttle stick from a self-neutral
system to a ratchet system, install the optional slider.
Then, remove the spring and swing arm.
Twist with long-nose
pliers.
Remove the
spring and
swing arm.
Install the optional
slider.
•CRYSTAL REPLACEMENT
•When changing the band, remove the crystal holder and
change the crystal. (Except 72. 75MHZ)
•Futaba Digital Proportional Frequencies (FOR
U.S.A.)
The frequency of Futaba digital proportional sets can be
changed among bands (1) ~ (6) on the 27MHz band only.
However, a 27MHz band set cannot be changed to 72MHz
band, and vice versa.
Therefore, always, attach the correct frequency flag to
the end of the transmitter antenna. Each frequency band
has its own designated color, as stated above. The fre-
quency flag is intended for identification purposes.
Also change the frequency flag when frequency is
changed.
• Futaba paired crystals are precisely matched. Always use
a Futaba crystal set (transmitter, receiver) when changing
the frequency.
It is illegal to change crystals of transmitter on the 72-75
MHz bands in the U.S.A.
Frequency Channel No. Flag Color
•SWIVEL STICK SETTING
To adjust the operating direction of the stick lever, loosen
the four screws shown in the figure and turn the stick
body and set it to the best position. After setting the
stick, retighten the four screws.
(1)
Loosen these four screws.
(3) Tighten these four
screws.
(2) Select the angle by
turning the stick body.
Stick lever can be set
within this range.
. 5°
4
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Futaba ATTACK at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Futaba ATTACK in the language / languages: English as an attachment in your email.

The manual is 1,78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info