29051
7
Zoom out
Zoom in
Previous page
1/12
Next page
A common power supply regulator and diode may also be supplied with the speed controller, depend-
ing on the vehicle kit. Since they cause a voltage drop, always remove them.
TO BUYERS OF THE NEW ATTACK-BFR (FP-R102GF)
When using a Futaba motor control amp (MC-106,
106B, 108, 109, 110, etc.) instead of the speed
controller supplied with the vehicle, turn off the
ASP system as shown in the figure.
•Set the transmitter power switch to ON, then set the receiver power switch to ON. The servos stop near the neutral
position. Operate the transmitter sticks and check if each servo faithfully follows operation of the sticks.
R102GF ASP
release
connector
Insert the ASP release co-
nnector packed with the
set at this 2P connector '
(male pins) on the printed
wiring board.
From transmitter
when switch turned
on
From receiver when
switch turned off
• Connect the pushrod to each servo horn, then check if the direction of travel of each servo matches the transmitter
operation.
When transmitter
stick lever set to the
right
Vehicle also steers
to the right
6
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Futaba ATTACK at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Futaba ATTACK in the language / languages: English as an attachment in your email.

The manual is 1,78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info