29051
4
Zoom out
Zoom in
Previous page
1/12
Next page
•LOADING THE PENLIGHT BATTERIES
Remove the battery cover at the rear and insert eight penlight batteries in the correct polarity.
Remove the cover by push-
ing here and sliding down.
Load the eight pen-light
batteries while paying care-
ful attention to their-polarity.
Extend the antenna fully and set the power switch to ON.
The level meter pointer should deflect to the silver zone. If the point-
er does not move, or moves very little, check for poor battery con-
tact, incorrect battery polarity, or faulty batteries.
If the pointer of the level meter deflects to the red zone, the range of
the radio waves will become short. When the pointer drops to the
boundary between the silver and red zones, change the batteries.
•The
trim
levers
are
used
to fine
adjust
the
steering
angle.
They
are
used to adjust the neutral position and for correcting the running
posture after the mechanism is mounted. After test running, make
corrections with the rod adjuster, etc. and operate the set with the
trim levers in the neutral position as much as possible.
•Servo reverse switches
(NEW ATTACK-R. NEW ATTACK-BFR)
This switch makes servo rotation to another-
direction.
After fixed servos onto your model, and found
that rotation is wrong-way, switch to another
direction.
•Servo reverse switches are located at bottom of
Transmitter case like drawing below:
•Steering trim lever adjustment
Normal Reverse
Normal Reverse
Steering servo
reverse
switch
Throttle
servo reverse
switch
When vehicle was run straight
When vehicle turns
to the right
Move the trim lever slowly
to the left so that the ve-
hicle runs straight.
When vehicle turns
to the left
Move the trim lever slowly
to the right so that the
vehicle runs straight.
When vehicle was run straight.
•Adjust the trim lever so that the vehicle runs straight on a smooth road.
The throttle trim lever is used to fine adjust the speed controller stop position, etc.
3
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Futaba ATTACK at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Futaba ATTACK in the language / languages: English as an attachment in your email.

The manual is 1,78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info