29003
14
Zoom out
Zoom in
Previous page
1/101
Next page
11
You may adjust the stick tension of your sticks to provide the “feel” that you like
for flying. To adjust your springs, you’ll have to remove the rear case of the
transmitter. First, pop off the battery cover on the rear of the transmitter. Next,
unplug the battery wire, and remove the battery and RF module from the transmitter.
While you’re removing the RF module, pay attention to the location of the pins that
plug into the back of the module. Next, using a screwdriver, remove the four screws
that hold the transmitter’s rear cover into position, and put them in a safe place.
Gently ease off the transmitter’s rear cover. Now you’ll see the view shown in the
figure below.
Using a small screwdriver, rotate the adjusting screw for each stick for the desired
spring tension. The tension increases when the adjusting screw is turned clockwise,
and decreases for counterclockwise motion.
When you are satisfied with the spring tensions, you may close the transmitter.
Check that the upper printed circuit board is on its locating pins, then very carefully
reinstall the rear cover being careful thread the RF module connector pins through the
hole in the case and not to bend them. When the cover is properly in place, tighten
the four screws.
Aileron
Elevator
Stick
Stick
Upper
printed
circuit
board
Lower printed circuit board
Rudder
Mode 2 transmitter with rear cover removed
Aileron
Elevator
Stick
Stick
Upper
printed
circuit
board
Lower printed circuit board
Rudder
Mode 1 transmitter with rear cover removed
If you wish to change the mode of the transmitter, say from mode 1 to mode 2, turn on
the transmitter holding the two
buttons down. You’ll see a display “STICK
MODE X,” where X is a number representing the current transmitter mode. Press
the plus (+) or minus (–)
key to change the mode number as desired.
You’ll see the effect of you changes when you next turn on your transmitter. In
some cases, you’ll have to swap the throttle detent mechanism with the elevator
centering mechanism. This can be done by Futaba.
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Futaba 8UHPS at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Futaba 8UHPS in the language / languages: English as an attachment in your email.

The manual is 4,14 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info