29003
12
Zoom out
Zoom in
Previous page
1/101
Next page
9
PUSH
Charging jack
Battery cover
Battery connector location
Trainer function
/DSC function connector
RF module
To remove, press the tabs together
and gently pull rearwards.
To install, line up the connector pins with
the socket in the rear of the module and
gently snap into position.
Ni-Cd battery pack
NOTE: If you need to remove or replace the transmitter battery, do not pull on its
wires to remove it. Instead, gently pull on the connector’s plastic housing where it
plugs in to the transmitter.
The factory default functions activated by the switches and knobs for a Mode 2
transmitter are shown below. Note that some of the functions will not operate until
activated in the mixing menus. In general, functions for a Mode 1 transmitter
reverse the E and G switches.
Switch / Knob HELI ACRO GLID
Switch A Elevator Dual Rate
= PMIX-1, 2 on
Elevator Dual Rate Elevator Dual Rate
= Butterfly on
Switch B Rudder Dual Rate Rudder Dual Rate Rudder Dual Rate
Switch C CH 7
= ELEFLP on
center/
= Idle-down
= Airbrake on
= ELEFLP on
center/
= Idle-down
= PMIX-5 on
Switch D Aileron Dual Rate Aileron Dual Rate Aileron Dual Rate
Switch E Idle-up
= PMIX-5 on back = Speed
forward = Start (Launch)
Switch F Inverted/CH5
= PMIX-1, -2, -3 on
= PMIX-1, -2, -3 on
Switch G fwd = Throttle Hold Landing Gear GLID1FLP:Gear
Switch H Trainer Snap Roll/Trainer Trainer
CH6 knob Hovering Pitch Flap
(Flap trim if FLPRON on)
GLID1FLP: Flap
(Flap trim if FLPRON on)
GLID2FLP: Camber
(Flap trim if FLP-AI off)
CH7 knob Hovering Throttle Spoiler
(disabled if AI-DIF on)
Spoiler
(disabled if AI-DIF on)
CH8 knob CH8 CH8 CH8
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Futaba 8UHPS at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Futaba 8UHPS in the language / languages: English as an attachment in your email.

The manual is 4,14 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info