28989

Futaba 6XA Manual

41
Zoom out
Zoom in
Previous page
1/64
Next page
6->2 — Flap -> Elevator Mixing
Flap-to-elevator mixing trims the elevator to compensate for trim changes when the flaps
are commanded to drop or rise. This usually requires a relatively small amount of elevator
travel. The mixing point may also be offset to match the neutral flap position.
Inputting settings for 6 -> 2 mixing
1. Press one of the
MODE
buttons until the
6->2
window appears. The
default is for the function to be inhibited. Press the
CURSOR
key twice to
make the
INH
display flash on and off. To activate, press the (+)
DATA
INPUT
key. The
ON
display should flash on and off.
2. Press the
CURSOR
key once. At this time, the plus or minus sign in front of the numbers will
flash on and off. Check the direction the elevator moves: with down flaps , the elevator
should also go downwards, and for up flaps the elevator should rise (note, however, that
some models will need the opposite mix, so you’ll have to verify the proper direction by
flight test). To change the sign, press the (+) or (–) DATA INPUT key.
3. Now hit the CURSOR arrow again to get to the mixing rate setting. Now the little percent
sign will flash. You can use the (+) and (–) DATA INPUT keys to increase or decrease the
amount of mixing over or under the default 50% (pressing both DATA INPUT keys resets this
number to 50%).
4. Now move the flap knob to the position you’ll use in normal flight (flaps even with the wing,
probably). To make the mixing occur when you move the knob away from the normal
position, press both (+) and (–) DATA INPUT keys to enter the position. This changes the
position from which offset is applied to the elevator servo.
– 36 –
… 41 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Futaba 6XA at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Futaba 6XA in the language / languages: English as an attachment in your email.

The manual is 1,2 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Futaba 6XA

Futaba 6XA User Manual - Spanish - 55 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info