747936
54
Zoom out
Zoom in
Previous page
1/163
Next page
Receiver setting
FASST
Receiver setting
T-FHSS/ S-FHSS
HOME
screen
MENU 2
screen
or
MENU 1 screen
Pres
s
Pres
s
* When fail safe is set, that servo position is displayed.
Mode
Pre
Pres
s
Pres
s
54
Function
Fail Safe/Battery Fail Safe Function
Fail Safe/Battery Fail Safe Function
(All channel)
This function sets the servo operation position when transmitter signals cannot be received
by the receiver for some reason or the battery voltage has dropped.
-Fail safe mode
This function moves each servo to a preset position when the receiver cannot receive the
signals from the transmitter for some reason.
*The fail safe data is transferred from the transmitter to the receiver 10 seconds after the transmitter power was turned on.
The data is transferred every 10 seconds after that. Be careful because normally the trans-
PLWWHUSRZHULVWXUQHGRQ¿UVWDQGWKHUHFHLYHUSRZHULVWXUQHGRQQH[WDQGWKHUHLVQR
data transfer for about 10 seconds after the receiver power is turned on.
*For gasoline engine cars, for safety we recommend that this fail safe function be used to set the throttle channel in the di-
rection in which the brakes are applied.
-
Hold mode
This function holds the receiver in its position immediately before reception was lost.
-
Off mode (OFF)
This function stops output of signals to the servos and places the servos into the free state
when the receiver cannot receive.
The F/S, HOLD, and OFF modes are automatically reset when signals from the transmit
-
ter can be received again
-
Battery fail safe function (B-F/S)
If the receiver battery voltage drops below a certain value when this function is enabled,
the throttle servo moves to the position set by fail safe function. When the battery voltage
recovers, the battery fail safe function is automatically reset.
*This function cannot be used when the channel is not set to fail safe.
*When the receiver setting (P36) is "FASST", only CH2 (throttle) can use this function.
54


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Futaba 4PX at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Futaba 4PX in the language / languages: English as an attachment in your email.

The manual is 10,31 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info