648605
26
Zoom out
Zoom in
Previous page
1/62
Next page
Doc. P/N: WSP-009-004
Version: V1.3
Issue Date: August 2013
www.wassp.com
Page 26 of 62
Operator Manual
4.8.7 Processing Tab
The Processing tab contatins the options for 3
rd
party output and sonar processing.
4.8.7.1 Third Party Output Options
The output format to third party software can be selected here.
If you are outputting to the HYSWEEP
®
module of HYPACK
®
, select the HYSWEEP
®
output.
See “9. Hydrographic Software Integration” on page 31 of the Installation Manual for more
information.
If you are outputting to QINSy, select the QINSy output.
If you are having trouble receiving NMEA sentences from the installed sensor, or if your sensor
is not supported by QINSy or HYPACK
®
but is supported by WASSP, enabling the output of HDT
and TSS may x this.
4.8.7.2 Beam Distribution
Equal Distant
This distribution sets the sonar beams at a xed separation across the swath, resulting in
a seaoor line with evenly separated detection points. This will give a more even sounding
density:
Equal Angular
This distribution sets the sonar beams at equal angles from port to starboard, meaning that,
on a at seaoor, the detection points are more numerous near the middle of the swath, and
less numerous at the sides, putting more soundings where the soundings are likely to be more
accurate:
Ignore Degrees to:
Adjust the swath width if you nd that
detections at the swath edges are
causing issues with seaoor mapping.
e.g. With 10º ignored on each side, the
middle 100º of the swath will be used to
map the seaoor.
In rough/noisy conditions, this could
save time on post-processing.
Figure 21. Ship Setup Options - Processing Tab
26


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Furuno WMB-3250 Wassp at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Furuno WMB-3250 Wassp in the language / languages: English as an attachment in your email.

The manual is 10,53 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info