522194
44
Zoom out
Zoom in
Previous page
1/100
Next page
3. INITIAL SETTINGS
3-8
11.Remove the appropriate rubber cap of the cylinder to bleed air.
12.Press the W (or X) key until the indicator is completely filled (in black).
13.Remove the appropriate rubber cap of the cylinder to bleed air.
14.Repeat steps 10-13 to bleed air completely.
Rudder limit setup
15.Go back to the [DOCKSIDE SETUP] menu. Select [RUDDER LIMIT SPEED] and
push the knob.
Set the rudder center position, then set the maximum rudder limits or "hard-over" points
for the rudder system.
NAVpilot will AUTOMATICALLY set the port/starboard direction of the rudder angle in this
step. It does not matter which way the rudder reference unit arm or linear sensor rod is
installed as this correction will be done electronically.
NAVpilot will AUTOMATICALLY "linearize" the rudder indication values if the rudder turns
further in one direction than the other direction. Therefore, it is recommended that you
make both port and starboard rudder values the same. This will avoid confusion for the
customer during operation. Also, numeric value selected is not critical and need not be
measured as long as you feel that your estimation is close to the proper value.
16.The cursor is selecting [RUDDER CENTER SETUP]; push the knob.
17.Turn the helm so rudder is centered then push the knob. The [RUDDER LIMIT
SETUP] menu appears.
18.Rotate the knob to select [PORT LIMIT SETUP].
19.Turn the helm hard-over to port then enter port rudder limit.
20.Rotate the knob to select [STBD LIMIT SETUP].
21.Turn helm hard-over to starboard then enter starboard rudder limit.
Note 1: If the angle is wrong at step 16, 19 or 21 an error message appears. In this case
go back to the [RRU SENSOR ALIGNMENT] menu and check if the RRU setting is cor-
rect.
RUDDER CENTER SETUP
PORT LIMIT SETUP ??°
STBD LIMIT SETUP ??°
RUDDER LIMIT SETUP
CENTER RUDDER THEN PRESS
ENTER KNOB.
APPROX. CENTER RUDDER
AND PUSH ENTER TO SET
ARE YOU SURE?
YES ENTER NO MENU
44


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Furuno NavPilot 700 - Volvo Penta IPS at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Furuno NavPilot 700 - Volvo Penta IPS in the language / languages: English as an attachment in your email.

The manual is 7,98 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Furuno NavPilot 700 - Volvo Penta IPS

Furuno NavPilot 700 - Volvo Penta IPS User Manual - English - 7 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info