522194
46
Zoom out
Zoom in
Previous page
1/100
Next page
3. INITIAL SETTINGS
3-10
26.Go back to the [DOCKSIDE SETUP] menu, select [RUDDER TEST] then push the
knob. The cursor is selecting [NO]; push the knob. Select [YES] then push the knob to
start the test.
The rudder test automatically detects drive unit type as follows:
Successful detection
SOLENOID: The test automatically continues.
REVERSIBLE: The following menu appears. Select correct drive unit type with the
Course control knob and push the knob. Then, the test continues.
Note: IN PORT1 and INPORT2 are disabled when SAFE HELM is selected.
Failed detection
“RUDDER TEST FAILED” appears. The rudder test is discontinued.
When the rudder test is finished, the message "RUDDER TEST COMPLETED."
appears.
The results are shown on the screen as follows:
[DRIVE TYPE]: [REVERSIBLE12V](or 24V), [SAFE HELM 12V](or 24V), or SOLE-
NOID
[BYPASS/CLUTCH]: [NOT PRESENT] or [PRESENT]
[DB]: Rudder deadband. If rudder DB is higher than 1.3°, the boat cannot be con-
trolled correctly. In this case, open the [SEA TRIAL] menu, set [RUDDER DEAD-
BAND] to [MANUAL] then adjust rudder deadband so that no hunting occurs.
[SPD]: Rudder speed. If out of the recommended value for the NAVpilot, a warning
message appears.
[RUDDER DUTY]: PWM (Pulse Width Modulation) duty cycle for control of pump out-
put.
For solenoid systems, the rudder duty indication is 100% always.
For reversing motor system, this value should be in a range from 50% to 100% for
optimum performance. If the value is lower than 50%, the pump capacity is over-
sized for the steering cylinder volume. While the system may work well, there is a
chance that the pump will fail to start (stalled pump) when there is a heavy load on
the rudder system in heavy seas or large turns because the average voltage applied
to the pump is too low. If the rudder speed is lower than 3 degrees/s and the rudder
duty is higher than 90%, the pump capacity is undersized for the steering cylinder
volume. While the system may also work well, the NAVpilot control unit may not be
RUDDER SETUP AND AUTO TEST
DRIVE TYPE: -
BYPASS/CLUTCH: -
DB: - -.-° SPD: - -. -°/s
RUDDER DUTY: - -%
20 10 5 5 10 20
DRIVE UNIT SELECT MENU
DRIVE UNIT SELECTION
REVERSIBLE 24V
REVERSIBLE 12V
SAFE HELM 24V
SAFE HELM 12V
46


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Furuno NavPilot 700 - Volvo Penta IPS at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Furuno NavPilot 700 - Volvo Penta IPS in the language / languages: English as an attachment in your email.

The manual is 7,98 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Furuno NavPilot 700 - Volvo Penta IPS

Furuno NavPilot 700 - Volvo Penta IPS User Manual - English - 7 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info