641191
22
Zoom out
Zoom in
Previous page
1/58
Next page
-1.14-
1.10 Receiving
You can select a receiving frequency by one of the following methods:
- Direct frequency entry, or
- Channel number entry
Adjusting RF gain:
In normal use the RF GAIN control should be set for maximum. If the audio on the received
channel is unclear or interfered with other signals, adjust (usually reduce) the RF gain to improve
clarity.
Clarifier adjustment:
If reception is unclear, try to clarify the signal as follows. For manual entry of frequency, simply
turn the FREQ/CH control for fine tuning.
1. Press the [3] CLARIFY key. (if a frequency is selected by CH NO., the cursor which was
located at the channel number, moves under the 10 Hz place.)
2. Turn the FREQ/CH control to fine tune the receiver on the wanted frequency.
3. To terminate this operation, press the [3] CLARIFY key again. The cursor returns to the
channel number.
NOTE: The clarify working range can be adjusted, by an authorized FURUNO representative,
for ± 100 Hz or ± 150 Hz (factory setting: ± 150 Hz) on system code 9921. Note however that
the range on AM is fixed at ± 5 kHz (100 Hz steps).
S - Meter:
During reception, the meter works as a Sensitivity
Meter indicating the relative signal strength
coming into the receiver frontend. While in
transmission, it indicates the antenna current.
NOTE: S-meter will not work with AGC off.
02
4
6810
S
Monitoring traffic on intended transmit frequency:
When a semi-duplex (two-frequency simplex) channel is selected, it is recommended to monitor
if there is no existing traffic on the frequency you are going to use. To do this, press the [RX] key
followed by the [ENT] key. The transceiver unit monitors traffic on the selected frequency for 3
seconds.
Receiving AM broadcasting stations:
1. Press the [1] MODE key repeatedly until H3E with AGC is selected.
2. To tune in a 15,260 kHz shortwave station, for instance, press as below:
[RX], [1], [5], [2], [6], [0], [0], [ENT]. Do not miss the last zero.
22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Furuno FS1562 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Furuno FS1562 in the language / languages: English as an attachment in your email.

The manual is 0,55 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info