641191
24
Zoom out
Zoom in
Previous page
1/58
Next page
-1.16-
ITU channels:
To select the scan group (band or channel), shift the cursor to either the position of the band or
channel number by pressing the [2] CURS key. (Band scan is useful to watch frequencies on the
same channel in different bands.)
2. Press the [6] SCAN key, and “SCAN” appears. The receiver starts scanning, stopping at a
channel where the signal is stronger than the scan-stop level. The receiver will restart
scanning when the traffic goes out of that channel.
For example, the scan group is “channel” and scan starts at ITU 1203:
R
02
4
6810
S
LOW
J3E
AGC NB SWEEP SCAN
SIMP
3. To stop scanning, press the [6] SCAN key. “SCAN” disappears from the operation display.
1.12 Frequency Sweep
Sweep is the function where the receiver searches for a signal within a selected frequency
coverage. For sweep operation, the AGC function should be ON.
The defaults of respective parameters are as follows:
Sweep stop signal level 3
Sweep stop time 2 s
Sweep width 100 kHz
Step frequency 1 kHz
These can be adjusted on system codes 9951 through 9954.
NOTE: Sweep width is the frequency width to sweep on both sides of the selected frequency.
Sweep step is the frequency interval at which the receiver sweeps the sweep width.
Procedure
1. Select the sweep center by key operation.
2. Press the [6] SCAN key. “SWEEP” appears and the receiver starts sweeping.
3. To stop sweeping, press the [6].
24


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Furuno FS1562 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Furuno FS1562 in the language / languages: English as an attachment in your email.

The manual is 0,55 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info