522181
21
Zoom out
Zoom in
Previous page
1/40
Next page
1. MOUNTING
12
2°-10° transom angle (stepped transom and jet boats): Position the shim with the tapered end
down.
19°-22° transom angle (small aluminum and fiberglass boats): Position the shim with the ta-
pered end up.
3. If the bracket has been temporarily fastened to the transom, remove it. Apply a marine sealant
to the threads of the three #10 x 1-1/4" self-tapping screws to prevent water seeping into the
transom. Screw the bracket to the hull. Do not tighten the screws completely at this time.
4. Repeat step 1 to ensure that the angle of the sensor is correct.
Note: Do not position the sensor farther into the water than necessary to avoid increasing
drag, spray, and water noise and reducing boat speed.
5. Using the vertical adjustment space on the bracket slots, slide the sensor up or down to pro-
vide a projection of 3 mm (1/8”). Tighten the screws.
Cable routing
Route the sensor cable over the transom, through a drain hole, or thorough a new hole drilled in
the transom above the waterline.
Never cut the cable or remote the connector; this will void the warranty. Always wear safety gog-
gles and a dust mask.
2°-10°
transom angle
Shim with
taper up
parallel
11°transom
angle
No shim
parallel
19°-22°
transom angle
Shim with
taper down
parallel
12°-18°
transom angle
Slight angle,
no shim
Cable coverCable cover
Cable
clamp
Hull projection 3 mm (0.12”)
50 mm (2.0”)
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Furuno BBDS1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Furuno BBDS1 in the language / languages: English as an attachment in your email.

The manual is 3,62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info