522181
23
Zoom out
Zoom in
Previous page
1/40
Next page
14
2. WIRING
2.1 Connections
Connect the MFD8/12/BB, TZT9/14, power cable and transducer cable as shown in the figure be-
low.
Ground
Connect the ground wire (1.25sq) to ship's ground to prevent interference to the picture. Shorten
the ground wire as much as possible. For FRP vessels, install a ground plate that measures about
20 cm by 30 cm (8” x 12”) on the outside of the hull bottom to provide a ground point.
Note: Use a "closed-type" lug to make the ground connection at the Bottom Discrimination
Sounder.
BATTERY
NETWORK
MODE SW
1 2 3 4
XDR 12-24 VDC
1.1-0.4 A
1
+
3 GND
BBDS1
MOD-Z072-50+ cable, 5m
(2/10m, option)
TRANSDUCER
12-24 V DC
Black
White
Shield (green)
Ground
GROUND WIRE
IV-1.25sq
HUB-101
MJ-A3SPF0028-035C
cable
MFD8/12/BB,
TZT9/14
MOD-WPAS0001-030+ cable, 3m
(std. supply for MFD8/12/BB,
TZT9/14)
CAUTION
Ground the equipment
to prevent mutual
interference.
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Furuno BBDS1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Furuno BBDS1 in the language / languages: English as an attachment in your email.

The manual is 3,62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info