522181
19
Zoom out
Zoom in
Previous page
1/40
Next page
1. MOUNTING
10
Note 1: Do not mount the sensor in an area of turbulence or bubbles: near water intake or dis-
charge openings; behind strakes, struts, fittings, or hull irregularities; behind eroding paint (an in-
dication of turbulence).
Note 2: Avoid mounting the sensor where the boat may be supported during trailering, launching,
hauling, and storage.
Note 3: For single drive boat, mount on the starboard side at least 75 mm (3.0") beyond the swing
radius of the propeller.
Note 4: For twin drive boat, mount between the drives.
Installation of Bracket
1. Cut out the installation template (enclosed with transducer) along the dotted line.
2. At the selected location, position the template, so the arrow at the bottom is aligned with the
bottom edge of the transom. Being sure the template is parallel to the waterline, tape it in
place.
Warning: Always wear safety goggles and a dust mask.
3. Using a 4 mm, #23, or 9/64" bit, drill three holes 22 mm (0.9”") deep at the locations indicated.
To prevent drilling too deeply, wrap masking tape around the bit 22 mm (0.9") from the point.
Fiberglass hull: Minimize surface cracking by chamfering the gelcoat. If a chamfer bit or coun-
tersink bit is not available, start drilling with a 6mm or 1/4" bit to a depth of 1 mm (0.04")
Height without
speed sensor
191 mm (7.5”)
Height with
speed sensor
213 mm (8.4”)
Height
75 mm (3.0”)
minimum beyond
the swing radius
Slope of hull parallel to
waterline.
Deadrise angle
Align template vertically
Align template with the
bottom ed
g
e of the
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Furuno BBDS1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Furuno BBDS1 in the language / languages: English as an attachment in your email.

The manual is 3,62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info