560834

Friedland GlobalGuard Home Alarm System Manual

26
Zoom out
Zoom in
Previous page
1/232
Next page
26
7.7 Personal attack facility
The user can trigger an alarm at any time in the event of threat or danger by activating the personal attack facility.
Remote control
Control panel
1. Press and hold the button for 3 seconds.
1. Press and hold the personal attack button for 3 seconds.
The alarm will continue for the alarm duration when the system will automatically reset or until the system is disarmed.
7.8 Zone lockout
If, while the system is armed, a single zone triggers an alarm more than three times and zone lockout is enabled, the zone will
be locked out. The siren will ignore other alarm signals from the zone. An alarm will not be triggered. The zone lockout will be
cancelled when the siren is disarmed. If zone lockout is disabled, a single zone can initiate any number of alarms. Zone lockout
operates with alarm zones only. Zone lockout does not operate with fire zones.
7.9 Device tamper
The tamper zone operates on a 24-hour basis. Receipt of a tamper signal from any device will immediately trigger an alarm
irrespective of systems armed/disarmed status unless the system is in test mode or program mode.
If the battery cover of any device (except remote controls) is removed or if the siren or the control panel is removed from the
wall, an alarm will occur immediately even if the system is disarmed (unless the system is in test mode or program mode). The
alarm will sound until the set alarm time expires or the system is disarmed from the remote control or the remote keypad.
7.10 Chime facility
You can only operate the chime facility with the system in standby mode.
1. Press the button to enable the chime facility.
2. Press the button again to disable the chime facility.
Note: To operate the chime facility using a security detector, set the chime mode for the zone of the security detector to “ON”.
7.11 Spectra lighting (manual/automatic switching)
1. Press the button to switch the linked Spectra lighting ON.
2. Press the button to switch the linked Spectra lighting OFF and back to automatic operation.
7.12 Keyboard beeps
1. Press the button to mute the keyboard beeps.
2. Press the button again to unmute the keyboard beeps.
7.13 Entry/exit delay beeps
If the entry/exit delay beeps are enabled, you can temporarily disable them during the active delay period only.
1. Press the button to mute the entry/exit delay beeps.
2. Press the button again to unmute the entry/exit delay beeps.
Note: When the next entry/exit delay period starts, the beeps will follow the main system setting as normal.
7.14 Event log
The event log indicator flashes every 5 seconds to indicate that a new event entered into the event log. Only alarm events will
cause the control panel to beep every 10 seconds. Other system events (e.g. low-battery condition) will not initiate the warning
beeps.
Take one of the following actions:
- Press the button to switch off the event log indicator.
- Press the button to read the event message in the event log.
Each event message is shown on two displays. The first display shows the event number and when the event occurred. The
second display shows the actual content of the event.
… 26 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Friedland GlobalGuard Home Alarm System at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Friedland GlobalGuard Home Alarm System in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 3,42 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Friedland GlobalGuard Home Alarm System

Friedland GlobalGuard Home Alarm System Installation Guide - English, German, Dutch, French, Italian, Portuguese, Spanish - 120 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info