560830

Friedland FGGA04 Series Manual

9
Zoom out
Zoom in
Previous page
1/71
Next page
9
6 Operation
This section only describes the operation of the siren when operating without control panel (single zone).
6.1 Arming the system
When leaving the premises, the system must be armed. Make sure that the siren is in operating mode. Before arming the
system, make sure that all doors and windows are closed and that the available PIR movement detectors are not obstructed.
Make sure that animals are restricted to areas not protected by PIR movement detectors.
6.1.1 Instant-arm mode
The instant-arm mode will immediately arm the system. If the system is armed, activating any security detector will
immediately trigger an alarm. When entering the premises, disarm the system before opening any door or window protected
by a door/window contact detector or entering an area protected by a PIR movement detector. In the instant-arm mode, arm
and disarm the system from outside the premises using the remote control or the remote keypad.
Remote control
Remote keypad
1
Press the button.
Enter the 4-digit ID code. Press the button.
The siren emits one beep. The indicators in the front lens and the learn indicator flash once.
6.1.2 Delay-arm mode
The delay-arm mode will arm the system with a 15-second entry/exit delay. The siren will emit one beep and another beep
after the 15-second delay has expired to allow time to leave the premises before the system is fully armed. When entering the
premises by opening any door or window protected by a door/window contact detector or entering an area protected by a PIR
movement detector, the system will be triggered and the siren will emit one long beep. However, the alarm will not sound until
the 15-second delay has expired. Disarm the system using the remote control or the remote keypad during the 15-second delay.
If an alarm occurs, the siren will sound continuously until the set alarm duration time expires. The alarm will stop and the
system will re-arm. The alarm lockout feature will prevent the system from re-arming after repeating the process three times.
Remote control
Remote keypad
1
Press the button.
Enter the 4-digit ID code. Press the button or the
button.
After the 15-second delay has expired, the siren emits one beep. The indicators in the front lens and the learn
indicator flash once to indicate the system is fully armed.
6.2 Disarming the system
Remote control
Remote keypad
1
Press the button.
Enter the 4-digit ID code. Press the button.
The siren emits two beeps.
Note:
If the system is disarmed and the siren emits ten quick beeps, an alarm has been triggered while the system was
armed.
6.3 Personal attack facility
The user can trigger an alarm at any time in the event of threat or danger by activating the personal attack facility.
Remote control
Remote keypad
1
Press and hold the button for 3 seconds.
Note: On earlier remote control models, slide the
personal attach switch.
Press and hold the button or the button for
3 seconds.
The alarm is triggered. The siren will sound.
6.4 Device tamper
If the battery cover of any device (except remote controls) is removed or if the siren or the remote keypad is removed from the
wall, an alarm will occur immediately even if the system is disarmed (unless the siren is in service mode). The alarm will sound
until the set alarm time expires or the system is disarmed from the remote control or the remote keypad.
… 9 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Friedland FGGA04 Series at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Friedland FGGA04 Series in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 1,15 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info