624062

Fluke networks TS 100 Cable Fault Finder Manual

7
Zoom out
Zoom in
Previous page
1/20
Next page
3
Physical Characteristics
Physical Characteristics
See Figure 1.
bfz01.eps
Figure 1. Physical Characteristics
A
Power button, which turns the tester on and off.
B
Low battery LED.
C
Female BNC (British Naval Connector).
D
LCD display with units indication in feet (FT) or
meters (M).
E
The battery compartment is on the back of the
tester. The battery cover includes a label showing
some common velocity of propagation (VOP)
values.
F
The two smaller buttons are used to adjust the
tester’s VOP up or down. See “Velocity of
Propagation” on page 6.
Line Cords and Accessories
Use only line cords (test leads) approved by Fluke
Networks. Other cords may cause incorrect
measurements. For information on availability of
additional line cords and accessories, contact your
local Fluke Networks authorized distributor.
Operation
WXWarning
DO NOT USE the tester to test cables that
may have hazardous voltages present.
When the tester indicates
the presence of
high ac voltages, CAREFULLY DISCONNECT
IMMEDIATELY to prevent any personal
injury. Hazardous dc voltages can be present
on any cable at any time. The tester does
NOT detect or indicate the presence of dc
voltages. Use care when connecting to
cables.
Do not use the test set if it is damaged.
Before you use the test set, inspect the case.
Look for cracks or missing plastic. Pay
particular attention to the insulation
surrounding the connectors.
Always handle the clip leads and the cables
by their insulation, NEVER directly by the
conductive wire. Use only the insulated clips
provided to connect to any wire or cable.
… 7 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fluke networks TS 100 Cable Fault Finder at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fluke networks TS 100 Cable Fault Finder in the language / languages: English as an attachment in your email.

The manual is 0,55 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info