763943
128
Zoom out
Zoom in
Previous page
1/134
Next page
8588A/8558A
Operators Manual
124
Examples of the use of Special Event Qualifiers
You have set up a system to make a series of DCV measurements if the input
signal reaches 0.9 V and continue to take measurements until the level reduces
below the threshold. The input signal is a varying DC voltage. The Initiate layer is
set to Continuous ON, the ARM layer events to Immediate. The Trigger layer is
setup to start taking measurements when the input signal reaches the preset
level. The required level can be manually set within the Trigger Setup menu. The
remote commands (from the default) are:
TRIGger:SOURce INT
TRIGger:LEVel 0.9
TRIGger :SLOPe POSitive
You have no control of the signal level to set the level above 0.9 V so you cannot
do a quick check that everything is correctly configured. To test that the system
will take measurements as required, you can send a special event qualifier
remote command to take one measurement:
TRIGger:SIG
The default Delay will be executed before the reading acquisition triggers. To
override the Delay, you would send TRIGger:IMMediate. Note that
TRIGger:IMMediate is not the same as TRIGger:SOURce IMMediate.
128


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fluke 8588A at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fluke 8588A in the language / languages: English as an attachment in your email.

The manual is 1,84 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Fluke 8588A

Fluke 8588A User Manual - German - 134 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info