539572

Florabest FBS 43 A1 Manual

62
Zoom out
Zoom in
Previous page
1/70
Next page
GB
- 64 -
fuel. Pour the correct quantities of petrol and
2-stroke oil into the mixing bottle (see scale prin-
ted on the bottle). Then shake the bottle well.
6.4 Fuel mixing table
Mixing procedure: 40 parts petrol to 1 part oil
Petrol 2-stroke oil
1 liter 25 ml
5 liters 125 ml
7. Operation
Please note that the statutory regulations gover-
ning noise abatement may differ from one loca-
tion to another.
Each time before use, check the following :
•
That there are no leaks in the fuel system.
•
That the equipment is in perfect condition and
that the safety devices and cutting devices are
complete.
•
That all screws are securely fastened.
•
That all moving parts move smoothly.
7.1 Starting the engine when cold
Fill the tank with the oil/petrol mix. See also „Fuel
and oil“.
1. Set the equipment down on a hard, level sur-
face.
2. Press the fuel pump (primer) (Fig. 1/Item 7)
10 times.
3. Move the On/Off switch (Fig. 1/Item 9) to
„I“.
4. Secure the throttle lever (Fig. 1 / Item 11).
To do this, press the throttle lever lock (Fig.
1/Item 12) and then press the throttle lever
(Fig. 1/Item 11) and lock the throttle lever by
pressing the lock (Fig. 1/Item 10) at the same
time.
5. Set the choke lever (Fig. 1/Item 5) to “ ”.
6. Hold the equipment fi rmly and pull out the
starter cable (Fig. 1/Item 4) until you feel it
begin to resist. Then tug sharply on the starter
cable 4 times. The equipment should start.
Important: Never allow the starter line to
snap back. This may result in damage.
Important: Since the throttle lever is secu-
red, the cutting tool starts to operate when the
engine is started.
Then release the throttle lever by actuating it once.
Actuating the throttle lever will also release the
choke lever. (The engine returns to its idle state).
7. If the engine does not start up, repeat steps
4-6 above.
Please note: If the engine does not start up
even after several attempts, read the section
„Troubleshooting“.
Please note: Always pull out the starter cable
in a straight line. If it is pulled out at an angle,
friction will occur on the eyelet.
As a result of this friction, the starter line will
become frayed and will wear away faster.
Always hold the starter cable when the starter
line retracts.
Never allow the starter line to snap back
when it has been pulled out.
7.2 Starting the engine when warm
(The equipment has been idle for less than 15-20
min.)
1. Set the equipment down on a hard, level sur-
face.
2. Switch the On/Off switch to “I” (Fig. 1 / Item
9).
3. Secure the throttle lever (Fig. 1 / Item 11) (in
the same way as described in “Starting the
engine when cold”).
4. Hold the equipment fi rmly and pull out the
starter cable until you feel it start to resist. Then
tug sharply on the starter cable. The equip-
ment should start after 1-2 tugs. If the equip-
ment does not start after 6 tugs, repeat steps
1 – 7 of the procedure for starting the engine
from cold.
Anleitung_3401991_LB2.indb 64Anleitung_3401991_LB2.indb 64 24.02.12 14:0924.02.12 14:09
… 62 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Florabest FBS 43 A1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Florabest FBS 43 A1 in the language / languages: German, Dutch, French as an attachment in your email.

The manual is 3,85 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info