679100

Florabest FBKS 52 A1 - IAN 302393 Manual

16
Zoom out
Zoom in
Previous page
1/53
Next page
FBKS 52 A1
■ 12 
│
 GB
│
IE
│
NI
Cleaning the air filter
Contaminated air filters reduce the engine output due to low air supply to
the carburettor.
Regular inspection is essential. The air filter
must be inspected regularly
and cleaned if necessary.
The air filter
must be checked more frequently if the air is dusty.
♦ Remove the cap for the air filter cover
by turning it in an anticlock-
wise direction.
♦ Remove the air filter cover
.
♦ Remove the air filter
.
♦ Clean the air filter
by tapping or blowing it out (with compressed
air).
Assembly is done in the reverse order.
CAUTION!
► Never clean the air filter
with petrol or flammable solvents.
Cleaning the chain drive
RISK OF INJURY!
► Always wear protective gloves when handling the saw chain
.
There is a danger of injury from the sharp cutting teeth!
NOTE
►
Clean the chain drive after each use.
♦ Place the chainsaw on a level and stable surface.
♦ Pull the front hand guard backwards as far as the stop to release
the chain brake (see fold-out page fig. C).
♦ Remove the two locking nuts
using the spark plug spanner
.
♦ Remove the sprocket cover
.
♦ Carefully remove the saw chain
from the guide rail and the
chain sprocket
.
♦ Remove the guide rail
.
Clean it with a brush.
♦ Now clean the entire chain drive area and the saw blade cover
with a brush or by blowing it out with compressed air.
Assembly is done in the reverse order.
Maintaining the spark plug
♦ Pull off the spark plug connector .
♦ Remove the spark plug using the enclosed spark plug spanner
.
♦ Assembly is done in the reverse order.
■ Electrode gap = 0.6 mm (distance between the electrodes between
which the ignition spark is generated). Check the spark plug for con-
tamination after the first 10 hours of operation and clean it with a
copper wire brush if required.
Afterwards, service the spark plug after every 50 hours of operation.
Maintaining the chain lubrication
■ See the section "Checking and adjusting the chain lubrication".
Maintaining the carburettor settings
■ If the saw chain moves when the engine is idling or the engine goes
out when you release the throttle, you need to adjust the carburettor.
NOTE
► Have the carburettor adjustment (e.g. adjusting the idling speed)
carried out by qualified specialists only to prevent engine damage.
Maintaining the guide rail
♦ Remove any remaining burrs on the edge of the rail using a metal file.
♦ Clean the guide rail
groove using a brush or with compressed air.
Replace the guide rail
as soon as the groove is worn.
♦ Turn the guide rail
after every use to ensure even wear.
♦ Check that the sprocket at the tip of the guide rail
moves freely.
Lubricate it if necessary with a little bearing oil.
Fitting the guide rail and tensioning the saw
chain
WARNING!
► Always switch the engine off before fitting parts.
RISK OF INJURY!
► Always wear protective gloves when handling the saw chain
.
There is a danger of injury from the sharp cutting teeth!
NOTE
► A new saw chain
stretches and must be tightened more regularly.
Check the chain tension regularly after every cut and adjust this as
required.
► Depending on wear, the guide rail
can be turned.
♦ Place the chainsaw on a level and stable surface.
♦ Pull the front hand guard
backwards as far as the stop to release
the chain brake (see fold-out page fig. C).
♦ Remove the two locking nuts
using the spark plug spanner
.
♦ Remove the sprocket cover
.
♦ Push the slotted hole of the guide rail
over the two protruding bolts.
♦ Lay the saw chain over the teeth of the chain sprocket . Guide
the saw chain
precisely in the direction indicated on the guide rail
.
There is a guide wheel at the tip of the guide rail
in whose teeth the
saw chain must be laid.
♦ Lightly pull the guide rail
to pre-stress the saw chain .
… 16 …


Need help? Post your question in this forum.

Forumrules
1

Forum

florabest-fbks-52-a1---ian-302393

Reset search

  • lOOK FOR ON / OFF SWITCHES FOR ELECTRIC SAW FOR Florabest FKS 2200 D2 Submitted on 25-8-2020 at 20:21

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Florabest FBKS 52 A1 - IAN 302393 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Florabest FBKS 52 A1 - IAN 302393 in the language / languages: English, German, Dutch as an attachment in your email.

The manual is 3,08 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info