Manual Florabest FBKS 52 A1 - IAN 302393 (page 17 of 53) (English, German, Dutch)

679100

Zoom out

Zoom in

1/53

FBKS 52 A1

│

13 ■

♦ Put the sprocket cover back on.

Make sure that the chain tensioner pin

on the inside ﬁts into the

appropriate hole

on the guide rail .

Adjust the chain-tensioner screw

as required using the ﬂat-head

screwdriver

♦ Tighten the two locking nuts

hand tight.

Do not tighten them too ﬁrmly.

♦ Use the ﬂat-head screwdriver

to turn the chain-tensioner screw

clockwise until the lower part of the saw chain

slides into the guide

rail

The saw chain

must lie against the underside of the rail.

When the chain brake is released, you should be able to pull the saw

chain

over the guide rail by hand.

NOTE

► A new saw chain

stretches and must be tightened more regularly.

♦ Tighten the two locking nuts

hand-tight using the spark plug

spanner

Sharpening and caring for the saw chain

RISK OF INJURY!

► Always wear protective gloves when handling the saw chain

There is a danger of injury from the sharp cutting teeth!

NOTE

► A properly maintained and sharpened saw chain reduces the

amount of bodily eﬀort and level of wear and produces a better

result.

► Clean, maintain and sharpen the saw chain regularly.

► Check the saw chain regularly for cracks and damaged rivets.

► A grinder can be attached to the grinder support

for a secure

grip during grinding.

► Use only special Ø 4.8 mm (3/16") round ﬁles for saw chains for

the supplied saw chain.

► You will ﬁnd detailed information on sharpening in a sharpening set,

e.g. an Oregon set.

► Alternatively, you can use an electrical saw chain sharpening device

and follow the instructions of the manufacturer.

► If you have any doubts about carrying out the work, the saw chain

should be replaced.

► If necessary, have the sharpening of the saw chain

carried out

by a specialist workshop.

■ Required parts (not supplied):

– Ø 4.8 mm (3/16") round ﬁle for saw chains

– Flat ﬁle

– Depth limit setter

♦ File using forwards movements only to remove material.

♦

25°

10°

File at an angle of around 25° at an inclination

of 10° to the guide rail

♦ Check the clearance of the depth limiter with a depth limit setter.

0,6 mm

The correct clearance of the depth limiter should

be 0.6 mm (0.024").

Maintenance intervals

The ﬁgures given here are based on normal operating conditions. In the

event of more diﬃcult conditions, such as strong dust generation and

longer daily working hours, the given intervals are to be reduced corre-

spondingly.

Appliance

part

Action Before

starting

work

Weekly In the

event

of an

error

In the

event

of dam-

age

As re-

quired

Chain

lubrica-

tion

Checking

Saw

chain

Check

and note

sharpness

Check

chain

tension

Sharpen X

Guide

rail

Check

(wear,

damage)

Cleaning X X

Replace X X

Ordering replacement parts

The following information should be provided when ordering replacement

parts:

■ Type of appliance: Petrol chainsaw

■ Item number of the appliance: IAN 302393

■ Appliance ID number: FBKS 52 A1

NOTES ON THE SAW CHAIN

► Recommended Oregon saw chains:

– Oregon E 72 (e.g. available in DIY stores)

– Oregon 20LPX072E

– Oregon 20LPX072X

– Oregon 20BPX072E

– Oregon 20BPX072X

► Pay close attention to the following speciﬁcations when purchasing

from alternative suppliers:

x 72

1.47 mm

0.058“

÷ 2 .325“

Chain pitch: 8.25 mm (0.325")

Drive link thickness

(Groove width): 1.47 mm (0.058")

No. of chain links: 72

lOOK FOR ON / OFF SWITCHES FOR ELECTRIC SAW FOR Florabest FKS 2200 D2 Submitted on 25-8-2020 at 20:21
Reply Report abuse

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Florabest FBKS 52 A1 - IAN 302393 in the language / languages: English, German, Dutch as an attachment in your email.

The manual is 3,08 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Florabest FBKS 52 A1 - IAN 302393 Manual

Product: